Question about Minolta Office Equipment & Supplies
Copier konica minolta bizhub 363 displays error message/code c-2201
Posted by Anonymous on
Remove the toner bottle let machine thur its paces when it says install toner bottle install correctly
Posted on Feb 19, 2015
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Is there network card is installed in it, if yes then you can configure it with your network go to machine Manu in machine control panel and the in network settings here you can give the IP address and subnet mask after then reboot the machine.
If network card is no installed behind the machine then you can use its built-in USB or and parallel printer without NIC card.
Posted on Feb 02, 2008
SOURCE: bizhub 350 error code
c3852 means low fuser(hot section) temp setting. hold down utility or stop key, then you should be abel to do trouble reset. if problem persist it would most likely be a lamp or a sensor, which will require a technician to come out.
Posted on Apr 16, 2008
First check the alignment front and rear of the finisher, check the finisher exit guide rollers if the paper is exiting properly, open both rear and the front cover and check the lower gears attach is the up/down drive belt. that lower gear one might be broken by the pin slot.
Posted on Jul 09, 2009
Tips for a great answer:
Mar 15, 2017 | Konica Minolta Office Equipment & Supplies
Apr 21, 2014 | Konica Minolta Office Equipment & Supplies
Mar 07, 2013 | Konica Minolta bizhub C250 All-In-One...
Feb 24, 2012 | Minolta Office Equipment & Supplies
Power off the machine. Then remove the toner bottle be careful the hole might be on the bottom toner is going to go everywhere. Then close the toner cover and turn on the machine. Let the machine go through it normal routine. When it asks for toner install the toner correctly. If THE KUNB on the side of the bottle is damage put a new one in that KUNB is what the toner motor uses to turn the bottle if it is damaged you get a code. If that does not work you might have a bad motor or the home sensor or actuator for the toner bottle is bad worse case the control board is bad
Feb 24, 2012 | Minolta bizhub 350 Black and White Copier
Aug 05, 2011 | Konica Minolta Office Equipment & Supplies
224 people viewed this question
Usually answered in minutes!