Question about JVC GR-D250 Mini DV Digital Camcorder

2 Answers

HI, I have a gr-250, doesn´t turn on,

My gr-250 does´n turn on, I already try and removed the battery for 30 seconds, and it still doesn´t turn on. would some body help me?

Posted by on

2 Answers

Re: HI, I have a gr-250, doesn´t turn on, - JVC GR-D250 Mini DV Digital Camcorder Video Cameras

You got to check if it is charged or not

Posted on Mar 31, 2007

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer
Re: HI, I have a gr-250, doesn´t turn on, - JVC GR-D250 Mini DV Digital Camcorder Video Cameras

Is the battery charged.

Posted on Feb 25, 2007

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

I own a jvc-d93 digital video camera and when recording the screen is black and the words lens cap appear even though the lens cap is off,can you help.

Please check whether the Camcorder is fully charged. Then, try resetting the Camcorder to the factory settings. Try Power resetting the Camcorder.
To Power reset the Camcorder, remove the battery of the Camcorder press the ON button(if switch, then keep the switch in ON position) for 30 seconds and reinsert the battery in 1 minute. Then, check the operation of the Camcorder.
If the issue still persists, then service will be required. It seems to be an issue with the CCD of the Camcorder.

Jul 26, 2010 | JVC Cybercam GR-D93 Mini DV Digital...

2 Answers

Shows fault E04 remove & reattach battery

Do a search of this problem and you will ind that every JVC owner is having the same problem. I finally got mine "reset" by powering the unit on in payback mode while holding down the "play" button. Then, turn it back off and power it on in the camera mode while holding down the "rec" button. This seems to have reset it and I've not had anymore issues SO FAR!
Good luck with it.

Apr 28, 2009 | JVC Video Cameras

1 Answer

When I turn on the digital video camera (JVC GR-D65OU) it says "Remove lens cap" but the lens cap is off, please help


When this error again shows up try pressing the reset button for 10 seconds to reset the camcoder. It will be a small black button, which can be pressed using a ball pen or pin.

Please do rate this solution as FixYa if found useful and revert for further assistance.


Apr 21, 2009 | JVC GR-D73E Mini DV Digital Camcorder

1 Answer

Shows fault E04 remove & reattach battery

Hi, Regarding the above fault with my JVC camcorder, I have solved the problem by removing the tape and replacing with a new one. Thanks anyway.

**** Coupe

Mar 30, 2009 | JVC Video Cameras

1 Answer

Safe guard mode

Turn off the camera and put it in a cool, dry place for about 30 minutes, then turn it on again.

Sep 10, 2008 | JVC GR-D250 Mini DV Digital Camcorder

2 Answers

Lens cap?

Try removing the battery, wait 30 seconds, and plug it back in. That may reset the lens cap sensor.

Aug 11, 2008 | JVC Cybercam GR-D72 Mini DV Digital...

1 Answer

Jvc video camera

there is a repir thing with certain models see below. CCD Failure/Lens Cap Warning Error JVC has received reports that in certain circumstances, the following models may, while in the camera mode, show no picture, a distorted picture and/or display “LENS CAP” even though the lens cap is removed. We have identified the probable cause as a failure of the CCD image sensor. Repairs of units exhibiting these problems as a result of a defect in the CCD image sensor will be made free of charge at a JVC Authorised Service Centre even if the unit is outside warranty.
Please call our Consumer Support Department on 0870-330-5000 to obtain your free repair. We apologise for any inconvenience and we appreciate your understanding and support.
Please note that this offer expires on 30th June 2009 and is applicable only to failure of the CCD image sensor.
This information applies to the following models:
GR-D18, GR-D20, GR-D21, GR-D22, GR-D225, GR-D23, GR-D24, GR-D30, GR-D31, GR-D32, GR-D33, GR-D34, GR-D40, GR-D43, GR-D50, GR-D53, GR-D54, GR-D60, GR-D63, GR-D70, GR-D73, GR-DX25, GR-DX27, GR-DX28, GR-DX35, GR-DX36, GR-DX37, GR-DX45, GR-DX47, GR-DX48, GR-DX55, GR-DX57, GR-DX67, GR-DX75, GR-DX77, GR-DX78, GR-DX95, GR-DX97, GR-FX15, GR-FX16, GR-FXM39, GR-FXM393, GR-FXM40, GR-FXM404, GR-PD1, GR-SX19, GR-SX25, GR-SX26, GR-SXM29, GR-SXM30, GR-SXM49, GR-SXM50, JY-HD10.

May 26, 2008 | JVC GR-D20EK Camcorder

1 Answer

Eo4 error code

HI SIR the fault is caused either by the take up or supply reel in the camera they are not rotating when the tape is inserted.maybe A defective tape or hung reel brake can cause this issue.or maybe a bad loosen guide of the tape path is lame , Try replacing the tape, if this does not resolve the problem you may need to seek professional service to have the reels checked. thanx and plz try to rate and remember i am here just to help u thx

May 08, 2007 | JVC GR-SXM920 Camcorder

1 Answer

Dvx 90 a problem

hi if you have the last messege on this page:,m16857,gm92/JVC-GR-DVX90EG-Mini-DV-Digital-Camcorder.aspx then .... good luck

Apr 02, 2006 | JVC GR-DVX90EG Mini DV Digital Camcorder

Not finding what you are looking for?
JVC GR-D250 Mini DV Digital Camcorder Logo

Related Topics:

115 people viewed this question

Ask a Question

Usually answered in minutes!

Top JVC Video Cameras Experts

Steven Wander
Steven Wander

Level 3 Expert

574 Answers

Larry Stiles
Larry Stiles

Level 2 Expert

286 Answers

Shekar Avadhani

Level 2 Expert

60 Answers

Are you a JVC Video Camera Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides