Question about Photography
Posted by Anonymous on
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Don't have the motor switch in the still position when loading -make sure it is on FORWARD. Look at the little holes in the film and make sure the film is on the same side as the little grooves on the drive gear.
PS -let the bulb cool off before try to move the projector ,the bulbs are very expensive and hard to find.
If you do use the still position to view a frame do it for just a few seconds or the bulb will burn the film. Good luck- Tom.
Posted on Aug 12, 2008
The drive belt on the porjector maybe broken. They tend to be made of rubber like an elastic band and tend to get hard and break easily. If this is the case, you may be able to substitute a large elastic band to replace the origional part.
Posted on Aug 27, 2009
I found a web (D'Antiques Movie Projectors ) site for an 482a projector which is almost identical to the 481a projector. It had the information I needed.
You also dalled and provided a toll free number at which I may be able to purchase an owners manual.
Posted on Dec 27, 2009
Super 8 and Regular 8mm are the same film, the difference being the way they were supplied to the consumer - 8mm was supplied loose on a reel, Super 8 was supplied in a pre-loaded cassette. Both can still be purchased new from B&H Photo and other dealers.
Posted on Sep 04, 2011
Tips for a great answer:
Dec 05, 2016 | Cameras
Dec 05, 2016 | Cameras
Jan 01, 2016 | Office Equipment & Supplies
Mar 08, 2015 | Miscellaneous
This is a common problem with these projectors. Usually happens after a film breaks or a bad splice goes through it. Pull the lens straight out and then remove the lens housing that holds the lens and the focus controller. The screws for the housing are behind the glued on cover that says frame and focus. Remove the 4 screws behind it, slowly lift the cover and watch for a loose leaf spring that sits behind the cover. It will fall out if the projector is standing up, so lay it on its back and it will just sit there so you know where to put it during assembly.
Mar 26, 2013 | Canon Ps-1000 Canosound Super 8 Projector
Jan 02, 2010 | Cameras
Dec 08, 2009 | Cameras
Sep 14, 2009 | Cameras
May 20, 2008 | Photography
Mar 21, 2017 | Raynox Cameras
66 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: