The copier shows e000001-0002 - Office Equipment & Supplies

my dear you chek senor

You have a corrupted hdd promblem on you toshiba. You should find another hdd and the firmware and make them using usb stick

Well, first of all Francis, that isn't your error code, that's your meter (the odometer of the copier so to speak). Error codes will show C--- or E---
examples are C447 (fuser error) or E010 (fuser related jam)

sc 302 - charge roller current leak. strip the drum unit (dmu) and clean the unit

Hi how are you this is jack..

Dear you copier screen freez..
you press 0 and 8 key Simantenesly and other and on the copier.
when copier show CHECK TOTAL COUNTER.
WHEN you press 690 and start key. copier show 2 2
then you press ENTER AND when copier show REBORT THE MACHINE THEN OFF THE COPIER.. AND Simple ON.
Please vote me.
Thanks
Best Regards,

Hi how are you this is jack..... ([email protected])

Dear follw the procedure..
1 you press 0 and 8 key simantenesly and copier ON other Hand.
2 When copier windows show CHECK TOTAL COUNTER .
Then you press 263 and start key.... copier show a new windos.
Copier show YOUR OLD ADMAN CODE/PASSWORD.. Then you
READ HEAR AND CHANGE HEAR... PRESS ENTER KEY..
copier off.. and simple ON..

PLEASE VOTE ME..
Thanks
Best Regards,

During installation , use sharp ar205 developer and sharp ar021 toner cartridge. This shows you did not use developer or used the wrong ones, good luck.

Is this actually a Ricoh Aficio 1013F, or another model, because "CH551" is not a ricoh service code?Do you mean "SC551"
If so, this is a fuser "triac" problem (basically a fuse in the heater unit). It can only be reset in service mode after the problem is fixed...and will require a tech.

install kx-drivers for km-3530

the fuser unit has ceased to heat...it has a bad heater. the fuser is a hollow metal roller that usually has a powerful light inside to heat the metal. a continuity test can detect