My washer has been running abit more noisely the past few days during the final rinse (very loud humming), and now indicates "5d" and then does not complete the spin, drain cycle.....Help!
unplug. open the bottom panel,3 screws on bottom check the drain plug , remove the plug , mop up water , look inside for clogs , look above the ball, look inside the propellers, spin the pumps propeller by hand. reassemble. close panel. finally . feel around the inside of the front rubber gasket for items.
Was this helpful?
Yes
No
Popular Solutions for Whirlpool Duet GHW9150P Front
I have a leaking flow valve (part#8182862) on my whirlpool duet washer model#GHW9300PW4. I have a...
(More)
I have a leaking flow valve (part#8182862) on my whirlpool duet washer model#GHW9300PW4. I have a replacement valve, and have the existing valve exposed and disconnected on the interior of the washer chassis. The valve is held in place by a retention pin that passes through the back of the chassis into a side hole in the flow valve body. I am unable to figure out how to remove this retention pin. Can anyone clue me in on how to remove this pin and/or to physically separate the valve from the chassis?
I have the same problem, however I cannot find my manual. Can someone please walk me through the...
(More)
I have the same problem, however I cannot find my manual. Can someone please walk me through the steps I need to try before paying someone to come out and fix.