Paper feed I kep getting an error message saying the rpinter is outof paper. I have plenty of paper in the feed. it seems as if the paper is too wide to fit through the feed. It has worked very well for 2 years and now it does not work..any solutions or has this happened to you?

You may have a piece of paper jammed somewhere, open inspection hatches and check

Push something thicker than a plain sheet of paper through. Cut a side of a manilla folder into a 8.5"x11" and let the printer try to grab it during a copy. After doing it's normal "grab the right side until it's skewed and stop", continue to try to push it through.

Go to this link and look for your answer Techbelkin

Try unplugging from the wall for 5 minutes / plug in and retry, cancels / resets printer memory.

Had the same problem with mine, very intermittent. Remove all the paper and open the feed tray lid so you can get access to the three grey pinch rollers. Start printing then push on the roller with your finger to try and 'rough it up' (if it clicks you are pressing too hard).

The fault appears to be that the pinch rollers are loosing their grip and can not pull the glossy paper through. I dare say using a mild washing up liquid solution would be better but this is a safe quick fix.

Did this to mine and it has worked fine ever since.

Check the reg sensor for dirt etc and paper setting is correct in the paper tray

some faxes will shut down if it senses toner low/out
you must replace and maybe reset counter

try to look at your rollers made of black rubber, if they are shining then they need cleaning, if you know how to open the unit to get to all these rollers then you might be able clean them yourself with laquer thinner and a rag, where gloves and turn the rollers into the soaked rag and keep turning tight with lots of elbow grease until all rollers lost that shine.

check to make sure there isnt a foreign object in the paper feeder. Had the same issue awhile ago and found that the kids put a toy in it.