Question about Car Audio & Video

1 Answer

I have got steam in side my car aii ways - Car Audio & Video

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 550 Answers

Check for water leak in heater core
check for water leak in floor bungs(manufacturing holes in the floor pan filled with rubber plugs
check for water leak around windows doors
check for rust holes in rain gutters above doors, around door sills in floor pan
check that aircon is not set to recirculate air

Posted on Oct 27, 2008

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2007 chevrolet silverado

one way to tell is look on speaker it self it will be marked with a + and - or the pos will have red paint on it. another way is the smallest spade on the speaker is the positive side.

Aug 21, 2014 | Car Audio & Video

1 Answer

How do I wire a pair of type r 15 inch woofers to 2 pdx 1.1000 amps for maximum bass output

are u trying to run one speaker of each amp if so the should be dual voice coil jump one positive to the opposite side negative then take the positive thats not hooked up from one side and the negative thats not hooked up from the other side and run them to the amp but turn ur amp down all the way and work it up because one speaker will not handle all the power from one amp

Mar 30, 2012 | Alpine Car Audio & Video

1 Answer

Trying to remove a kenwood car stereo from a 91 vw golf

If you didn't purchase the radio new, then you probably don't have the pull tabs. New radios come with pull tabs. Basically they are designed to fit into both sides of the radio, just where the locks that keep the radio in the dash are. The old school method is the find the thinnest knives you can, one for each side. Remove the trim ring. Slide the knives (one on each side) inbetween the stereo and the metal mounting sleeve. You will need to keep both in place until your radio is about 1/2 way out. CAUTION, don't pushe the knives in too far, The locks are about 1 inch - 2 inches in.

Hope this helps

Aug 15, 2011 | Car Audio & Video

1 Answer

I recently installed some Audiopipe CRX-203 2 way crossover in my car along with some *** Tweeters ... the driver side works fine but the passenger side tweeter keeps burning out and gettin really hot....

Is it possible that the polarity of the tweeter is backward? Also, you may just have a defective tweeter. If it's heating up, it sounds like it may be bad.

Aug 13, 2011 | Car Audio & Video

1 Answer

I have found a PYLE POUNDER 8 inch speaker. I need to construct or purchase the correct enclosure for use as a car bass speaker or subwoofer. Need speaker and enclosure info.

making a sealed box would be the correct enclosure for that sub, th that image has one way you can have it look like, the black plastic piece is a connector point that is drilled out then glued to the side or back of the box, the other way is up side down/ reversed Any sealed enclosure will do, 8 inch are not that powerful so any enclosure.

Jun 04, 2010 | Car Audio & Video

1 Answer

Kicker DS 650 Car Audio positive side/negative side

The positive side is always bigger [wider]is the easiest way to remember.....just like a Batt in a car.. The pos. terminal is larger.

Dec 26, 2009 | Kicker DS650 Car Speaker

1 Answer

How to run an amp wiring kit in a mitsubishi verada ei 1998?

for the power wire try running it thru where your factory wiring harness go thru for the rest of the power or you may need to make your own hole... for the others,, pry up the side molding by your doors that are plastic, lay them under those very flatly so it'll still clip back in and you may need to run them on both sides if your power wire is thicker then 6ga.

then just try to run them underneath plastic moldings all the way back.. you can pull up your carpet if you really want to but its a lot of unneeded work if you go thru that way

Nov 18, 2009 | Car Audio & Video

1 Answer

Alpine type-r 2ohm dual voice coil help

try reconnecting your rca's from the deck to the amp when finished wire one speaker positive to positive on left channel and negative to negative on right channel then connect the 1st subwoofer. if all power and sound is fine and working turn off power to amp and connect negative terminal of 1st sub to positive on 2nd sub and positive from first sub to negative on second crossing the wires runs the speakers in series another way to try is parralel the speakers wiring by connecting positive left channel output of amp to positive on 1st sub same with the negative then splice positive to positive on second sub and same with negative.

Feb 09, 2009 | Alpine Type-R SWR-1222D Car Subwoofer

1 Answer

Car audio

what kind of car is it?

Dec 20, 2007 | Car Audio & Video

Not finding what you are looking for?
Car Audio & Video Logo

Related Topics:

71 people viewed this question

Ask a Question

Usually answered in minutes!

Top Car Audio & Video Experts

xxxxxx xxx

Level 3 Expert

4724 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers


Level 3 Expert

64034 Answers

Are you a Car Audio and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides