Question about Carrier Heating & Cooling

Open Question

Parts diagram for carrier package unit model 48tjd-016-650ay

Posted by on

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 116 Answers

SOURCE: Need wiring diagram

check the capicitor if it is domed up on top bad check the wires at the compressor to see if burnt take a insulated object and bump the contactor in to see if comp starts if so then out on low voltage circ check for call from stat on common to yellow then follow the connections may be out on low psi switch located in the suction line

Posted on May 10, 2009

Ad
farfield
  • 462 Answers

SOURCE: need wiring diagram for 1980's 3 ton package unit

I assume you know if this is correct voltage and single or 3 phase, and whether it will fit your application or not, how is the duct work going to attach, how many people will be in the conditioned area, what is the building made of, how much insulation is has...

A little more to it than just "turn it on".


If you get the models and serial and can contact the manufacturer or their representative you might get a wire diagram. Most any package unit would do. As long as you keep the original equipment controls. If you "patch" it up it may be hazardous by not having safety's where it was designed for. Or for instance It may have a anti freeze thermostat. By passing this could lead to coil freeze up and compressor damage. Leaving out a pressure switch (if any) may do the same or could become dangerous to people in the event of fan motor failure. A low temperature fan speed switch may not be needed now unless you plan to run the AC in below 55'f.
And a few dozen other factors that might need to be considered.


If you feel confident after this then contact carrier.

Please rate me as high as you can and thanks for using fixya.

Posted on May 19, 2009

  • 25 Answers

SOURCE: We need the wiring diagram(s) and/or service manual

the diagram should be on the inside of the electrical panel of the unit printed on a sticker

Posted on Aug 11, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

12 ton carrier package unit wiring diagram


heating or cooling mode? The wireing diagram is on the back of the electrical access door.

Jan 26, 2014 | Heating & Cooling

1 Answer

I ned the thermostat manual or at least a HOW to program it. I have a 48 GS 10 seer 80 AFUE gas package unit with Carrier digital thermostat TSTATCCNAC01-B if their are additional manuals on the unit...


carrier.com has the books look for the 48GS060 not the GX model thes units replced the SS and SX models in 97also the t-stats will be in accessories

Mar 05, 2011 | Heating & Cooling

1 Answer

We require condenser fan motors for Interclisa Carrier package (rooftop) air conditioner model AAD 250 (1980's model) model. Air conditioner - supply voltage 380 Volts 50 Hz AC. Condenser fan motor voltage...


Hi, this is an odd voltage 380 volts. Is it a 3 phase unit? To get a 220 volt 50hz condenser fan motor, you will have to go through a refrigeration/air conditioning parts house and order this. 60hz you would have no problem finding one in stock. Carrier is a good unit, and have been around for many years. You shouldn't have any problems locating one.
Sincerely,
Shastalaker7
PS You will need to go through a wholesale parts house.

Jan 21, 2010 | Carrier Heating & Cooling

1 Answer

We need the part number to order one Termostatic Expansion valve for Carrier package unit 50TJS014-551.


Go to HVAC parts.com and have your model number ready and they will have the part for you or cross it to another one that will work.

Nov 29, 2009 | Refrigerators

1 Answer

No heat need a wireing diagram 1997 package unit


impossible to get wiring diagram without model or manufacturer

Nov 21, 2009 | Heating & Cooling

1 Answer

Trying to identify the year of manufacture on different carrier package units


the date will usually be in the serial number week/year ex 1509
if its not in the serial just about all the parts will havve a 4 digit number like this

Aug 05, 2009 | Carrier Heating & Cooling

2 Answers

Carrier package heat unit Model 50TJ-006---600 Unit is around 20 degrees and at 425psig on the high side...frost lines on the evaporator coil...high is super hot and the suction line is mild...no cooling...


reclam the units refrigerent and wight it to what it says on the compliance plate then put it on the vacum pump for a hour then recharge the system and see what happens.or you might hav a faulty compressor.

Jun 09, 2009 | Carrier 50TJ028 Rooftop Electric Cool Air...

1 Answer

Need wiring diagram for 1980's 3 ton package unit


I assume you know if this is correct voltage and single or 3 phase, and whether it will fit your application or not, how is the duct work going to attach, how many people will be in the conditioned area, what is the building made of, how much insulation is has...

A little more to it than just "turn it on".


If you get the models and serial and can contact the manufacturer or their representative you might get a wire diagram. Most any package unit would do. As long as you keep the original equipment controls. If you "patch" it up it may be hazardous by not having safety's where it was designed for. Or for instance It may have a anti freeze thermostat. By passing this could lead to coil freeze up and compressor damage. Leaving out a pressure switch (if any) may do the same or could become dangerous to people in the event of fan motor failure. A low temperature fan speed switch may not be needed now unless you plan to run the AC in below 55'f.
And a few dozen other factors that might need to be considered.


If you feel confident after this then contact carrier.

Please rate me as high as you can and thanks for using fixya.

May 19, 2009 | Carrier Heating & Cooling

1 Answer

Burners wont ignite


does unit have thermo-cupling

Nov 23, 2008 | Carrier 52PQ307 Wall/Window Air...

Not finding what you are looking for?
Heating & Cooling Logo

Related Topics:

207 people viewed this question

Ask a Question

Usually answered in minutes!

Top Carrier Heating & Cooling Experts

Dan Webster
Dan Webster

Level 3 Expert

8220 Answers

Donni Steen

Level 3 Expert

659 Answers

Bill Long

Level 3 Expert

587 Answers

Are you a Carrier Heating and Cooling Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...