Procom Model SN400TYLA Thermocoupler bad, can't find part

Question edited to toss in a load of CAPS!

Nope, if you can hear the motor then the motor is working. If it isn't blowing the fan just needs tightening up on the shaft. There is a small set screw with an Allen Key socket.

Click the images tab.

https://www.google.com/search?q=procom+blower+model+%23pf06-yjlf-f

..

ProCom Ventless products are equipped with an ODS pilot assembly, precision-engineered burners for clean burn and a non-adjustable regulator to prevent over-firing. The purpose of the ODS is to shut off the supply of gas to the heater/fireplace when the oxygen level drops below 18%.

We have the same issue. Gas is getting to the regulator. But it's not coming out to the pilot light. I tried for months to use my warranty and all I got were a few emails from procomusa but they havent done a thing. I bought an expensive wall decoration.

Sounds lie you need to replace the bimetallic strip by the pilot light. If that is bad the main gas nor the pilot will stay on.

Troubleshooting :: AZ Patio Heaters and Replacement Parts

azpatioheaters.com/pages.php?pageid=11

How do I replace starting striker switch on a tall patio heater? How do I clean ... Why is my burner flame low? Why does ... Why does my pilot light, but goes out when heateris turned on high or low? Why do I get a yellow flame and black smoke? ... 6. Can I convert my LP gas patio heater into a natural gas patio heater? NO.

Usually all it takes is you have to change the oriface size, I think natural gas is a smaller orifice.

that shouldnt matter u probably have a runner tube where the gas runs from burner to burner sometimes they get clogged or spiders can build webs in them ur best bet is to turn the gas off take apart and clean tat should solve ur problem

get it how
screwed back in valve?
nuts seized on?
carefull not to crossthred it, its brass and easily done, go with fingers untill you know it lined up ok

You need to first get a regulator which will go between the propane tank and the burner. You will need to know the burner capacity in BTU/HR and the pressure required. All of this can be found on the furnace specification plate or on the gas valve. It is a no brainer Circut!

Ray

gas pressure to low adjust 9 to 11 mb