Question about Video Game Consoles & Games

1 Answer

It shows 3

It runs for few seconds and stops then shows 3 even when you starts again it shows the same thing

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 6 Answers

What system are we discussing here?

Posted on Feb 19, 2012


1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My kenmore stick vaccum model. 116.36025510C stops after a few seconds and the light is blinking. This is after it indicates it has been fully charged


It sounds like the battery is no good, even if it shows full charge that doesn't preclude a defective battery.

Dec 01, 2016 | Computers & Internet

1 Answer

I have a 2000 stratus that has the 6 cylinder in it.. it wont start or if it does dies within seconds


honestly the crank sensor is the likely culprit. anything else and it should run, even if poorly.

Mar 01, 2014 | 2000 Dodge Stratus

1 Answer

I have a 1987 Plymouth Voyager that starts, fuel pump comes on but it just runs a few seconds and stops. If you turn the key off and back on, the fuel pump comes back on but shuts back off in a few se


On the fuel rail will be a small round valve type thing with a rubber vacumn tube running to it ,check the tube and make sure its connected as this will stop it from running as it opens the fuel rail for the injectors

Jan 03, 2013 | Cars & Trucks

1 Answer

1986 sei 1200 goldwing It will start from ignition on,fuel pump runs for a few seconds,fuel light goes out,every thing normal-no LED diagnostic lights.When it starts it will run for about 3-5 seconds &...


check the fuel filter it sounds like it's pluged and causing too much back presure this is causing an over load in the fuel pump causing it to stop working or to presure lock

Aug 03, 2009 | 1986 Honda GL 1200 Aspencade Gold Wing

1 Answer

Kenmore Dishwasher 5871525 stops running after a few minutes


sounds like a stuck key pad since you said the normal wash button flashed.. the other thing is try holding the door shut while you run it.. to see of it is maybe not latching properly..

Apr 10, 2009 | Kenmore 15762 Dishwasher

1 Answer

Please help


it is the timer or, it may be a short of some kind

Apr 19, 2008 | GE WDSR2080D Top Load Washer

11 Answers

Kenmore elite 790.3670 oven door locked


I held down the clear button for three seconds, it unlocked but still showed the lock button lit. It began beeping over and over. I opened the door and pressed the clear button again for three seconds. It stopped and the oven works just fine now. In fact, I used it right after I got it cleared out.

Feb 07, 2008 | Kitchen Ranges

1 Answer

Dryer turns itself on & beeps, then off again


aye, see if you can enter the diagnosis mode. What we are looking for is the F-02 code. This will flash when there is a stuck button or user interface problem and only displayed in the test mode. With the unit plugged in and all indicator lights off, select any button except stop. Press for 3 seconds, release for 3 seconds, press for 3 seconds, release for 3 secnds and press for 3 seconds. If you did it right 88 should appear. Press the same button again and if there is a error, it should show up. If no error code shows, open the consol and check the p-5 connector. This will be the interface ribbon to the board. Reseat it and see if the problem stops. Catriver

Jul 16, 2007 | Kenmore 67082 Electric Dryer

Not finding what you are looking for?
Video Game Consoles & Games Logo

Related Topics:

25 people viewed this question

Ask a Question

Usually answered in minutes!

Top Video Game Consoles & Games Experts

James Wishart

Level 2 Expert

122 Answers

yadayada
yadayada

Level 3 Expert

75797 Answers

Brad Brown

Level 3 Expert

15557 Answers

Are you a Video Game Console and Game Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...