Question about Audio Players & Recorders

Open Question

No sound right side ear cup of my Sony mdr xb300

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: 1 phone not working

WTF??? My shits stopped workin now to!!! LMAOO.. what a POS!!! hahahahaha, I see all you fawlkers with the same prob on the same pieces of shits!!! hahahahahaha, I am dyin laughin oer here!!! hahahaha, wow, what dicks... they dicked us on effin headphones.. fukkin bums!!!!! LOL

ohhh sheeeiit... time to go buy new ones i guess... BASTIDS!!

Posted on Jul 02, 2008

Ad
  • 1 Answer

SOURCE: ear pad replacement instructions for Sony MDR-V6 Headphones

Hello to all who have exhausted all avenues seeking instructions on how to remove and replace Ear Pads on Sony MDR-V6 Headphones.... All that is required is a little patience maybe some fingernails... The Pads simply slip on and off by pinching ends of cuff that is nearest the plastic backing of The Headphones by pulling them from their seat/flange .. i found it easiest to just roll the cuff off using my thumb w/rolling motion away from the plastic backing/housing of the headphones.. no tools required.. they are installed exactally like one would place a tire on a rim.. exact same motion is required as when removing a tire.. i can give no better illustruction than comparrison to tire removal and replacement. Be careful to make sure one end in completely set deeply into one side before attempting to pull opposing side over its side/flange..start on top and work way around to bottom or vise versa.. To get an idea of what you are attempting to do take a close look at new headphone pad rear and you will see the small flap of leather on rear .. there is a small overlap that fits perfectly over the flange.. dont try to force it as you may tear them...

Posted on Nov 14, 2008

  • 4 Answers

SOURCE: MDR-7506 - No sound on right side

It sounds like the pin cracked. If this is the case, you'll need to soldier a new jack on it. Here's how, assuming you already know how to soldier a new 1/8" TRS phono plug.

Cut and strip the cord. There should be two copper wires and (on Sony headphones, at least) a red and a green strand. On a new 1/8" jack, there should be three connections. The middle one is left, and is where the green one goes. The short one on the side is right, and is where the red one goes. The long bit is the common, and is where the copper one goes. Before you solder, however, remember which strand is which, because you have to sand or burn off the colored enamel. (Use a fine grain paper, or use a standard lighter or stick match- anything else might damage or melt the wire)

Posted on Apr 03, 2009

yabanada
  • 3 Answers

SOURCE: I need replacement ear pads for my Sony MDR-V-6

http://www.bhphotovideo.com/c/product/582208-REG/Pearstone_8091000_Pearstone_Replacement_Earpads_for.html#features

Price is right

Posted on Jun 13, 2009

  • 1 Answer

SOURCE: Can I replace the ear

Hey--it was reassuring to see that I'm not the only one with this question. Lots of places (Staples, Radio Shack) have the right size replacements, but it takes a little more digging to be sure you can find something more than what looks like doughnut-shaped packing material. B&H Photo Audio does, and here's a link: http://www.bhphotovideo.com/c/product/582208-REG/Pearstone_8091000_Replacement_Earpads_Pair.html

Posted on Jan 26, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Are there replacement ear pads that will fit on my 2005 Sony headphones ?


There are lots of generic (Chinese) replacement ear pads for Sony on ebay or Amazon, you'll just have to take some measurements and try to match what's available. Check the diameter in centimeters, and the shape (round or oval). You may not find a specific listing for MDR-RF960RK but a lot are interchangeable.

Nov 10, 2014 | Sony MDR-RF960RK Consumer Headset

1 Answer

Where can i buy ear cups for mdr-if5000


Try eBay and look for "Sony MDR-SA5000", that is SA and will work great as a replacement. You will find many vendors selling replacements for around 8 bucks. The vendors who are selling the exact replacements for the MDR-IF5000 are inferior to the original and cost more ($19.99). The SA replacements look exactly like the original and priced cheaper too, by about 1/3 the cost. They will be shipped from China, so if they offer free shipping could take up to 30 days to receive goods, just a heads up!

May 11, 2014 | Sony MDR-IF5000 Headphones

2 Answers

Sony MDR-RF4000K wireless headphones


Probably a bit late for the original poster, but just in case anyone else comes across this....

I also have the Sony MDR-RF4000K wireless headphones and the problem with the sound cutting out has got steadily worse over time, to the point where I felt like throwing them away. I replaced the batteries (use normal rechargeable AAs with a bit of card to trip the little switch that would normally be tripped by the Sony battery pack), however that had no effect on the problem.

After a little research I have established that the power on the headphones themselves is triggered by a pull switch in the right ear cup. When you put the headphones on, the padded headband is stretched and pulls the switch up, turning the headphones on. The headphones have always been a little big on me, and I can imagine that the headband has stretched permanently in the last few years, probably leading to the switch on being more marginal.

At any rate, although I don't have a fix, I now know that if the sound cuts out, I don't need to take the headphones off - just pull the headband up slightly on the right-hand side, or push the headphones as a whole down a bit, again on the right-hand side.

Jan 15, 2013 | Sony MDR RF4000K Wireless Headphones

1 Answer

Sony MDR-V300 Ear Cushions


Yes a firm on E-Bay sells the cushions.

Jun 21, 2010 | Sony MDRV300 Professional Headphones

1 Answer

Sony MDR-XB700 broken left ear


You could try to use a player with a stereo balance and adjust that, but in reality you need new headphones. Sonys have very comfortable and flexible cabling but the downside is that they wear out easily.

Mar 13, 2010 | Sony Audio Players & Recorders

1 Answer

Not getting any sound out of the right side. May have pulled a wire loose. How can I get in there to check ?


Try peeling the foam ear protection surround carefully off the left can to see if there are screw holes on the speaker mounting plate. Start by testing the cable from the stereo plug to the junction point inside the left can with a volt/ohm meter. The cable from the left side to the right side joins here. If the main cable is good, repeat the procedure with the right can and test from the junction to the wiring in the right can.

Oct 17, 2009 | Sony MDR-V150 Professional Headphones

5 Answers

Ear pad replacement instructions for Sony MDR-V6 Headphones


Hello to all who have exhausted all avenues seeking instructions on how to remove and replace Ear Pads on Sony MDR-V6 Headphones.... All that is required is a little patience maybe some fingernails... The Pads simply slip on and off by pinching ends of cuff that is nearest the plastic backing of The Headphones by pulling them from their seat/flange .. i found it easiest to just roll the cuff off using my thumb w/rolling motion away from the plastic backing/housing of the headphones.. no tools required.. they are installed exactally like one would place a tire on a rim.. exact same motion is required as when removing a tire.. i can give no better illustruction than comparrison to tire removal and replacement. Be careful to make sure one end in completely set deeply into one side before attempting to pull opposing side over its side/flange..start on top and work way around to bottom or vise versa.. To get an idea of what you are attempting to do take a close look at new headphone pad rear and you will see the small flap of leather on rear .. there is a small overlap that fits perfectly over the flange.. dont try to force it as you may tear them...

Nov 12, 2008 | Sony MDR-V6 Professional Headphones

Not finding what you are looking for?
Audio Players & Recorders Logo

Related Topics:

136 people viewed this question

Ask a Question

Usually answered in minutes!

Top Audio Players & Recorders Experts

kakima

Level 3 Expert

102366 Answers

 Grubhead
Grubhead

Level 3 Expert

5151 Answers

The Knight
The Knight

Level 3 Expert

74383 Answers

Are you an Audio Player and Recorder Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...