Question about Toys

1 Answer

Can't control my Dura V10 R/C helicopter more than 10 feet away...has new batters...do I need a new remote controller box?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Just bought furs v10, can't control it either. Opened it up and found battery loose, and antenna wire solder joint broken at PCB board inside helicopter. Flew it maybe 3 minutes. Not impressed!

Posted on May 08, 2012

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: New 27 MHZ Helicopter Controller won't turn on

I have a 27Mhz helicoper (looks identical to the one on the picture). I tried to fly it for the first time, but I am having problems controlling it. The left radio control lever sends the helicopter upwards, but the right hand control doesn't seem to do anything and that should make it go backwards and forwards. Can anyone help me as well please?

Posted on Feb 22, 2010

  • 1 Answer

SOURCE: My new u-control helicopter is experencing spinning

how much is it spinning after and if not to much adjust the st. trim on the controller.

Posted on Mar 05, 2010

  • 3 Answers

SOURCE: when i turn on the remote control, the red on/off

The batteries in the controller are nearly flat

Posted on Oct 02, 2010

micromatikal
  • 2777 Answers

SOURCE: Brookstone Silver Bullet Helicopter: When I

This is a battery fault, unfortunately pretty common. How old is this helicopter? It may still be under warranty.

Let me know, there is not really much of anything you can do on your end... you are doing everything correctly for sure.

Tim

Posted on Oct 09, 2010

  • 1 Answer

SOURCE: we have two gyros S107G remote control

Had the exact same problem. Found the solution on an Amazon posting:

1. To enable this function make sure both remotes and both helicopters are off.

2. Set the first remote's channel switch to the leftmost position (it says A, B, and C, but the s107 only supports 2 channels). Turn the remote on.?

3. Turn the helicopter that you would like to bind to the remote on and set the helicopter down on a flat stable surface for about 5 seconds. Try the throttle and the helicopter should respond to this remote.?

4. Next, to enable the second helicopter, set the second remote's channel switch to the rightmost position (it says A, B, and C, but the S107 only supports 2 channels). Turn the remote on.?

5. Turn the second helicopter on and set the helicopter down on a flat stable surface for about 5 seconds. Try the throttle and the second helicopter should respond to this remote.?


This worked for us.

Posted on Dec 26, 2010

Testimonial: "excellent help. thanks a ton. now we'll just hope for no mid-air collisions. appreciate it!"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Remote control won't work 10 feet away but if two feet away it works. What gives?


the remote uses light to send a signal to the tv. make sure there isn't anything interfering with the light signal. it could be dirty or the receiver could have dirt obstructing the light.

Mar 20, 2013 | Panasonic TC L42E50 - 42" VIERA E50 Series...

1 Answer

Just got a s301g Helicopter and it won't start up


Check the wiring where you plug in the charger to the helicopter. There is a red wire with quick disconnects. If its loose (the quick disconnect) you get this problem. In my case the helicopter came out of the box with this completely disconnected. It was hard to connect because there wasn't enough slack wire but once we did it the white light on the front of the helicopter came on and we were flying.

Nov 19, 2012 | Syma S301g Rc Helicopter 18" 3 Channel Rtf...

1 Answer

My Havoc Heli won't charge


http://www.buynicer.com/SWIFT6020--1-New-3--Channel-RC-Helicopter-w-Infrared-Remote-Control_pid8096.html

Aug 12, 2012 | Spinmaster Air Hogs Red Defender Remote...

1 Answer

The helicopter syma s032 not fly, noy function, not syncronize with the remote control. This charging for 90 minutes and the battery of the remote control is new. The helicopter light led is good, to...


0) Obviously, helicopter will operate best when fully charged... if charging light gets brighter when unplugged from helicopter, then it's not at full charge. Charge fully, then allow battery to cool for 10 minutes. Good batteries in remote also.
1) Power on helicopter.
2) Place on level surface and let gyroscopes sync. There is a red light inside the body (NOT the red/blue flasher in the nose) that will blink when you turn helicopter on, and will keep blinking until craft is level and stable for a few seconds, then will stop blinking.
3) Make sure left joystick is all the way down.
4) Power on remote.
5) Throttle up (left joystick) until blades move and then all the way back down.
This should get you flying. Let me know.

hope this helps,
r

Dec 28, 2010 | SYMA Toys industrial Syma S032 Ready to...

1 Answer

My s032 remote does not respond unless it is right next to the helicopter there is no throttle control or directional control somtimes it will start but then shutdowns unless you put the controller right...


Did you, by chance mess with the antenna? It's is the wire that came wrapped around one of the landing skids. It must remain like this, and ideally not in contact with too much metal. Also, on my s032 I've noticed that even indoors and at close range, the antenna on the remote should be extended fully. Is the helicopter charged fully?
Charging/Remote linking:
0) Obviously, helicopter will operate best when fully charged... if charging light gets brighter when unplugged from helicopter, then it's not at full charge. Charge fully, then allow battery to cool for 10 minutes. Good batteries in remote also.
1) Power on helicopter.
2) Place on level surface and let gyroscopes sync. There is a red light inside the body (NOT the red/blue flasher in the nose) that will blink when you turn helicopter on, and will keep blinking until craft is level and stable for a few seconds, then will stop blinking.
3) Make sure left joystick is all the way down.
4) Power on remote.
5) Throttle up (left joystick) until blades move and then all the way back down.
As a safety mechanism, remote disables itself if throttle is engaged at all when remote is turned on. Turn remote off, pull left joystick (throttle) all the way down, then try again.
This should get you flying. Let me know.

hope this helps,
r

Dec 28, 2010 | SYMA Toys industrial Syma S032 Ready to...

3 Answers

I have 3 s107 and I it says 3 channel on the box and the transmitter says A B C but will only let me select 2 of them. What's the trick on flying 3 at the same time?


Mine's exactly the same as yours. Although the transmitter shows A B C the switch has only two positions, so there's a choice of two only. I doubt it's possible to fly 3 at the same time.

Nov 08, 2010 | SYMA Toys industrial New Syma S107 Radio...

2 Answers

Hi ihave brought helicopter ftw 730 but the remote control was not its own .the helicopter ftw 730 remote control frequency is 40 mhz but the one i have is 27 mhz so how can i make as 40 mhz remote...


Unfortunately you can't. You will need to change the receiver or the transmitter so they are both the same frequency range eg 40mhz or 27mhz. Then you will need to check the crystal is the same frequency for the Transmitter and receiver eg 40.25mhz. NB. you can't put a 27mhz crystal into a 40mhz set or vise versa it won't work.

Aug 21, 2009 | RC Remote Control Rc Mini Helicopter

3 Answers

My new u-control helicopter is experencing spinning


how much is it spinning after and if not to much adjust the st. trim on the controller.

Aug 06, 2009 | Shuttle 9094 Emax Remote Control...

Not finding what you are looking for?
Toys Logo

Related Topics:

270 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toys Experts

kakima

Level 3 Expert

102366 Answers

yadayada
yadayada

Level 3 Expert

75117 Answers

ray gallant

Level 3 Expert

41478 Answers

Are you a Toy Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...