Question about Neovo X Computers & Internet

1 Answer

Problem with horizontal lines

My 1,5y old neovo monitor has started showing horizontal lines (about 1cm thick) all over the screen. When I don't have signal and the screen usually is blue now there are red and blue lines. When I use VGA or composite from any source I get some sort of inverted lines with the same with.

Posted by on

  • cocacolby Apr 23, 2008

    I have blue vertical stripes spaced out every few inches.

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Master
  • 669 Answers

The video controller circuit may be going sourer. The replacement could be more expensive than a replacement monitor.

Posted on Feb 17, 2018

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
sandrew
  • 2961 Answers

SOURCE: Neovo F-417 failure

You may need to set your laptop to send the video signal to a secondary screen, this will be done by right clicking on the desktop and clicking on graphics properties. Some laptops have a presentation mode on them it may well be there also.

Posted on Jan 29, 2007

wyoed1
  • 211 Answers

SOURCE: White lines & inverted picture at top of CRT TV image

This problem is normally the Vertical filter capacitors. You need to have them changed before it burns out the Vertical Chip.

Good Luck
Ed
NC Electronic
Mills Wyoming

Posted on Jan 07, 2008

SOURCE: Screen is black except briefly blue upon power on or putting source on "VGA"

Your backlights power inverter board is what causes this prob. It is a Darfon V144-001.

Posted on Jul 08, 2008

  • 1 Answer

SOURCE: small blue screen that says '' No composite input signal''

go to menu on the monitor and choose setting then reset the default

Posted on Nov 17, 2008

pgh_pa_guy
  • 2992 Answers

SOURCE: monitor shows ''NO SIGNAL''

This is normal. The monitor is telling you it is not getting a signal from the computer, which is true because you've turned off the computer. The monitor power is still on, however. The monitor power is not controlled by the computer power switch. Just turn it off with its power switch after you shut off the computer.

Posted on Nov 24, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Horizontal thick bar lines on the bottom of laptop monitor


Take it back to the retailer. Unless it is more than a year old. The graphics chip or screen has failed.

Mar 23, 2012 | HP Pavilion Computers & Internet

1 Answer

My Neovo F-417 started to get lines across the screen then the images fragmented - 10 minutes & it lost power totally.


Chris,

Try unplugging the monitor from any video cables. Only have the power cable plugged into and then turn it on. You should see a message that indicates there is no video source. If you do not see this message then the monitor has failed, and you'll need to call it in on it's warranty. (If it is still under warranty.) To call neovo - the number is 866-333-3686.

If it is out of warranty - it's going to be cheaper to buy a new monitor.

If the video message that there is no signal does display, then try plugging the monitor in with a different video cable and see if that has any results. If not, try plugging the monitor into a different computer. If it works on a different computer, you may have a bad video port on the computer you are plugging the monitor into.

Hope that information helps!

Nov 21, 2011 | Neovo F-417 17" LCD Monitor

1 Answer

I HAVE A NEOVO E-19A MONITOR. ON BOOT UP SCREEN GOES BLANK AFTER ABOUT 5 SECS. TURNING OFF THE MONITOR THEN TURNING BACK ON BRINGS THE SCREEN ON FOR APPROX 5 SECS BEFORE GOING BLANK AGAIN. THIS IS REPEATED...


http://www.devicemanuals.com/guide/LCD/AG%20Neovo/AG-Neovo-S-19A-LCD-Display-English-Owner's-Manual-T1RjMU9Uaz.html
dlc.sun.com/pdf/820-0119-10/820-0119-10.pdf
http://www.scribd.com/doc/3082274/AOC-LCD-Monitor-786LS-Service-Manual
Use these training manuals, to troubleshoot and sort your issue out.
Above is a user manual, and a service manual, in the service manual, are the troubleshooting steps to perform to isolate the problem, and hopefully repair.

May 25, 2010 | Neovo AG 17" LCD Monitor

1 Answer

AG Neovo Monitor not working


nothing you can reset from monitor other than color brightness. You can contact with AG Neovo as service.us@agneovo.com to have a RMA number and they will estimate you the repair fee if it is out of warranty.

Jan 06, 2010 | Neovo E-19A 19" LCD Monitor

1 Answer

LCD monitor have Vertical lines and black colour become greenish


normally the 19" resolution can support up to 1280*1024, but if it comes with vertical lines in full screen, it might indicate the panel is no longer to work and probably it's time to replace new one.

Aug 12, 2009 | Neovo S 19 19 in. Flat Panel LCD Monitor

1 Answer

ViewSonic monitor VS10780


i turn on after 30 sec turn off that happen all the time

Feb 19, 2009 | ViewSonic VA720 17" LCD Flat Panel Monitor

1 Answer

LGM578RIO1OOGRNAO-TO2, have this box with the letters showing at


There should be buttons on the monitor that will help you with menu issues if you don;t have a remote for it.
You also might want to Google the correct monitor,, as the one that you posted does not exist.

Jan 15, 2009 | Neovo F-417 17" LCD Monitor

1 Answer

Horizontal distortion, on the bottom half of the screen


By your description, you have a defective LCD. LCDs should have no linear distinctions and at best yours is having a problem with the inverter/cabling.

Reseat the cables, if using an adapter, see if you can try without one. Try a different video source. If issue remains, then have LCD serviced under warranty.

Oct 27, 2008 | Neovo X-17AV 17" LCD Monitor

1 Answer

Shimmer and bands


i experienced a tainted vertical black lines on the boths sides of my lcd screen. There was no scratch or whatsoever that could be the reason why thsi balck colored vertical lines to spread. Hope you can help me solve this problem. Thank you..


Jul 12, 2008 | LG Flatron L1710M 17" LCD Monitor

2 Answers

Horizontal lines on my monitor


I have a similar problem with a 2 year old Samsung monitor. I have tried to make a screen dump of it, but the horizontal lines do not show up then. This I have read indicates that the problem is in the monitor and not the video card.

Sep 17, 2007 | Computers & Internet

Not finding what you are looking for?
Computers & Internet Logo

Related Topics:

108 people viewed this question

Ask a Question

Usually answered in minutes!

Top Neovo Computers & Internet Experts

Questman
Questman

Level 1 Expert

6 Answers

Dimitar Todorov

Level 2 Expert

225 Answers

Cindy Wells

Level 3 Expert

5521 Answers

Are you a Neovo Computer and Internet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...