Question about kawasaki Full Suspension Mountain Bike Men

1 Answer

Zxr 400h 1990

Once bike is warm she cuts out. then she won't start leave for 10 to 20 mins she will start with a bit of a struggle.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that hasĀ over 10 points.

  • Contributor
  • 5 Answers

Hi mate i did have a zxr 400 l9 : and i didhav same problem its one of 2 things eather coil triggering pick up on flywheel or coil packs breaking down it took me agies to fin it good luck and let me no if you solv problem chears

Posted on Nov 01, 2008

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I have a cut 2-3in. in the iner blader (hull) of a Sevylor Colorado? Best way of repairing this ? Thanks

alrigth, for fast repair, i would use tuck tape( the red one) if you d'ont have anything else. you can also use an old bike tire tube, cut it open and take the piece you need to cover the entire cut and a little more. you want to use contact glue to make it work, to use the glue, put the glue on each pieces on the side you want to glue together. wait for about five minute(let it dry) in the meanwhile ,put the tube (the part that has the cut) on something flat, put the two covered glue surfaces together, put someting flat on top of it (just like a big sandwich) and put some wheigth on top of that, wait for 30 min and it should be repaired

May 18, 2011 | Sevylor 48 in Inflatable River Tube

1 Answer

Hi since weather has changed my zx9 wont staret just turns over i had the carbs balanced couple months ago i have put new battery on had plugs checked was told there fine oil and filter changed checked all...

hi m8t it sounds like a couple of things 1 you my have mioster in the wireloom thats why your useing a hairdryer under the tank..2the timeing my be out or the tappits my be loose reset them...3 the choke my be jammed just make sure that the choke runs freely on the sorry for the spelling...if the wireloom has water damage dry it of and tap it up hope this helps you

Nov 12, 2010 | kawasaki Full Suspension Mountain Bike Men

1 Answer

Qualcast Suffolk Punch 35s lawnmower running problems

There is a small idling mixture screw on the side of the carburettor.
As the engine is not well suited to the carb. it mainly runs on the idle setting!
As long as you are not leaving the choke on. This is a little tab on the top of the carb. You start with it set on C then soon set it on the middle position, and after about 3 mins turn it off.

Jul 12, 2010 | York Yankees Bedding MLB Comforter

2 Answers

Should I start or take my motorcycle for a ride during the winter

yes you should at least start it once a week. bikes do not take sitting well even in a garage. give it about 5 min run time. also add a fuel stabilizer to a fresh tank of gas.

Dec 05, 2009 | kawasaki Full Suspension Mountain Bike Men

2 Answers

KX80, overheating ?

I'm not familiar with this bike but it sounds like it could be air locked and causing it to overheat.I found the best way to remedy problems like this is to get it up to temp,shut off and lay bike down too one side then the other.Tilt forward then back,check to see if coolant level dropped.If that dont work pull a vaccum on cooling system and see if it holds when warm.

Nov 17, 2009 | kawasaki Full Suspension Mountain Bike Men

2 Answers

96 honda 300 fourtrax 4x4 shuts down after riding about 30mins

actually found my gas cap valve to be on the off position... :S not my proudest moment!

Aug 24, 2009 | Sport & Outdoor - Others

2 Answers

Starting my Mojave 250

check comprsion. check valve clearance.

Apr 26, 2009 | kawasaki Full Suspension Mountain Bike Men

1 Answer

A reg kawasaki gt 550

i would say you need to have your coil checked.

Nov 05, 2008 | kawasaki Full Suspension Mountain Bike Men

Not finding what you are looking for?
kawasaki Full Suspension Mountain Bike Men Logo

Related Topics:

83 people viewed this question

Ask a Question

Usually answered in minutes!

Top kawasaki Sport & Outdoor - Others Experts


Level 3 Expert

63386 Answers


Level 3 Expert

272 Answers

Kirk Augustin
Kirk Augustin

Level 3 Expert

2019 Answers

Are you a kawasaki Sport and Outdoor - Other Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides