How do i reprogram a wii control - Nintendo Wii Remote Controller

Try this link it may help. If not there may be an issue with the console or controllers. Try the controllers on a different wii. Try a different controller with your wii. Wii Remote Not Working or Syncing Correctly Wii and Wii mini Nintendo...

just open the battery compartment and press the red button then open the flap on the front of the wii console and press that red button. The lights will flash on the wii mote until one stays lit then it is paired

Are your controllers sync'd with the Wii? In another words, on the bottom of the Wii Controllers are 4 blue lights. Is one of those four lights illuminated? If not, it will not know that you're pressing it -- you will have to sync the wii remotes.

U have glitches in the reprograming back and forth.Take the battery out,about an hour.Reprograms the codes again,should work again.Don't reprograms the codes back and forth to many times or one times to many will kill the remote for good.U have 2 tvs,U should have 2 tvs remotes.

Well that depends if your trying to play gamecube games on the gamecube or the wii?, i assume your doing it on the wii because anyone would know that a wii control wouldn't work on a gamecube, not impossible, just very hard

wii remotes do work with the nintendo wii on wii games and on gamecube games, but it is better if you use a gamecube controller and plug it into the to holes under the flap, pictured below, hopefully.

Okay, on the front of the wii open the door where you'd put in an SD card, and take the battery covers off the remotes so you can access the reset buttons on both the console and remotes. Then press the red reset button on the wii and then within a second or two press the ones on the remotes. This should connect your remotes to your wii.

Take out any Gamecube controllers attached to your wii, then try it. the console might think you are using the gamecube controllers

becuse you have to turn it off and back on and press A until the first light lights up blue

Do you know where the SD Card slot is? If not, it's at the front just below the disc drive. Open the SD card slot entrance on the front, and take the back off the wii-mote. Turn the wii on, and at the health warning, hold the sync button on the wii-mote, and the one near the SD slot for 5 secconds. That should do it.

take off the battery compartment for the Wii Remote, and you should see a small red sync button. While the Wii is on, open up the flap for the SD cards, and you should see a red sync button on the Nintendo Wii. While holding the red sync button for the Wii Remote, press and hold the red sync button on the Nintendo Wii. After a few seconds, put the battery cover back on, and test the Wii Remote. Have any questions, feel free to ask. Use the add more details part in your question to ask any more questions. Thank you and have a good day.