Question about Hotpoint Washing Machines

1 Answer

Aquarius wdl540 drawer removal - Hotpoint Washing Machines

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 41 Answers

If you mean how to remove tumbler then remove the front casing and there should be four to six screws around the back edge.

Posted on Feb 15, 2012

  • juliebedz Feb 15, 2012

    No I was asking about how to remove detergent drawer

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Instruction manual for hotpoint aquarius WDL540 7kg Washer/dryer


My washing machine's indicator flashing after 5 minutes,what should i do?

May 13, 2012 | Washing Machines

1 Answer

Hi i have a leak under my hotpoint wdl540 the pipes are all clean and dry and the washing machine still works where would the water be coming from?


Could possibly be a little knick in the door seal or from the corner of the dispenser (the drawer in known to leak and the best remedy is to adjust the front feet so the unit is tipping back slightly, this allows gravity to help the flow of water in the drawer ). The valves could be leaking on the inner side if the machine, Really depends on whether it is a flood type leak or just a small puddle/drip. Run the machine pulled out, whilst stood on some newspaper, this should help trace the area of origin. Keep an eye out when it drains that your plumbing isn't blocked and so the drained water comes out of the standpipe instead of flowing away. Keep me posted or repost if you need further advice. All the best.

Oct 18, 2011 | Hotpoint Aquarius WD640 Front Load...

2 Answers

My hotpoint aquarius wdl540 keeps tripping the switch on the main fuse for the kitchen plug sockets


hello, the reason for this because theres a dead short inside washer or the socket may have a loose wire check all the earth wires inside the washer and the sockets get back to me if you still have trouble

regards
shaun

Jan 03, 2011 | Hotpoint Aquarius WD640 Front Load...

1 Answer

How do I remove the powder draw from the aquarius wml520, please?


1. Extend the dispenser drawer until the stop is reached.
2. Press the locking tab located in the centre rear of the drawer and pull the drawer out.

Mar 19, 2010 | Hotpoint Aquarius WMA56 Front Load Washer

2 Answers

Wdl540 clothes go through drying cycle but come


If there is no heat at all then the heater or the temp sensor or the thermal fuses are defective and need replacing.

Also check that the lint filter is clear of debris and lint. Rinse it if necessary in some mild washing up liquid in warm water and dry thoroughly. Check that the air outlet hose is clear if you have one fitted. Check that the condenser is empty of water and the case is free from dust and lint. Vacuum / brush or wash the outside of the collector in washing up liquid and warm water and dry.


Nov 06, 2009 | Hotpoint Aquarius WD640 Front Load...

1 Answer

Hotpoint wdl540, cant get the draw out


pull it out as far as it will go. Look inside you will see a clip at the top. depress this upwards and pull draw out

Sep 01, 2009 | Hotpoint Aquarius WD63 Front Load...

1 Answer

Programing a wash without drying


I had the dial on the wrong setting sorry to be a pain
Julie

Dec 01, 2008 | Hotpoint Aquarius WD63 Front Load...

2 Answers

Wf640 test


This has happend to me today! this is the fix
  1. Press and hold the Start/Cancel button until message clears
  2. Now press both Start/Cancel and On/Off buttons together until you get a dOFF message
  3. now your machine should work OK

Mar 17, 2008 | Hotpoint Aquarius WD640 Front Load...

Not finding what you are looking for?
Washing Machines Logo

Related Topics:

95 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hotpoint Washing Machines Experts

puggy666

Level 1 Expert

48 Answers

ptpumpman

Level 3 Expert

407 Answers

Cindy Wells

Level 3 Expert

5163 Answers

Are you a Hotpoint Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...