WHIRLPOOL SUPER CAPACITY 465 SF385PEGZ3 NO OVEN/BROILER
I went to light my oven and the oven and broiler both will not ignite all of a sudden. there are no clicks to either one of them. i let it preheat and still nothing. the clock and timer displays are all working fine. the stove top burners all work and all have spark to them and propane.
An expert who has achieved level 3 by getting 1000 points
An expert that got 10 achievements.
An expert that got 5 achievements.
An expert whose answer got voted for 500 times.
Re: WHIRLPOOL SUPER CAPACITY 465 SF385PEGZ3 NO...
Sounds like an issue with the spark module, altough that module tends to be really relliable.i would try removing pawer to te unit. checking the outlet for proper grounding,and replugging unit see if that works for you
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
I assume your talking about the ignition for the oven - the display doubles as the computer controller for the oven ignition and temperature control. Its likely you need a new LCD display board, its commonly known as the PCB or OCU.
Hello there Please read the entire solution i have provided below ok It won't bake or broilIf
neither the oven nor the broiler heats, but the range burners still
work, the clock may be set for a timed or self-cleaning cycle. Check to
be sure the clock buttons and knobs are set properly. If your clock has a
knob that says "push for man(ual)," push the knob in and try heating
the oven and broiler again. If they still don't work properly, you
probably have a defect in the thermostat, selector switch, or common
If the oven doesn't have a separate bake/broil/etc. selector switch,
the problem is often with the thermostat. It's not easy to check the
selector switch or thermostat for proper operation. If you suspect a
problem with either of these, call a qualified appliance repair
This sounds like the relay on the main board has failed. You will need to see if you have power going into the control. If you do replace the ERC (main control). You can also carefully inspect the board for burn marks if you see any replace it. Here is a link that will help you check and replace this http://appliancehelponline.com/ovenerc.html
I just had my ignitor replaced. The ignitor glowed but it must pull a certain amount of amps before it will allow the gas valve to open. Once the ignitor starts glowing the gas should come on within 30 seconds. Now that I saw it done I realize it was something I could have done myself. Be sure the tech does not try to slip you a used ignitor as mine tried.
I have the same problem intermittently on my Super Cap 465. After reading the following quote from another site, "There have been cases where radio waves, electronic signals and sometimes something as strange as dimmers in lights have caused some weird problems with some computer panels in stoves like these", I tried turning off lights that might be on the same circuit and wouldn't you know it, the oven igniter circuit worked.