Question about Hotpoint NBXR463EBWW Electric Dryer

1 Answer

Hotpoint dryer dryer starts fine but stops on its own and after a minute it restarts by itself, it wont run continuously

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Champion:

    An expert who has answered 200 questions.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

  • Expert
  • 310 Answers

Completely disassemble your vent from the dryer to where it exits the building. Clean out all lint. Disconnect the dryer from the electrical service and check for lint build up inside the machine. This lint build up usually makes the motor shut down on it thermal overload. Check the motor also to see if the air vents on it are blocked with lint. If no lint is present, the motor or the start relay need to be replaced.

Posted on Jan 12, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a maytag dryer that sometimes when I hit the start button will start and run for only a few minutes and stop and wont start again for a while and does a humming noise when it does star why?


Sounds like the motor is going into thermal overload (Getting hot) it may be caused by the motor itself, or could be overloaded by bearings or fan etc

Jul 28, 2014 | Maytag Dryers

1 Answer

Hotpoint Condenser Dryer Shuts Off After 5 Minutes


what is your model number is then we can get started then okay

Feb 01, 2013 | Dryers

2 Answers

I set my dryer time on my hotpoint model number DLB2650BDLWH and turn the start switch and i have to hold the star button until it times out. after a few minutes, it resets and i have to repeat the...


Hi

I believe that everything else is fine rather it is the thermal fuse that is located inside the rear panel to the exhaust duct that is bad and should be replaced. If you want you can test this fuse for continuity and if it is bad then it should be replaced, as it cannot be reset. If the fuse is fine then it can be due to the control board that is bad and should be replaced. Hope this helps...please post back for further assistance.

Daniel

Aug 27, 2011 | Hotpoint Dryers

1 Answer

GE dryer stops mid-cycle. If I try to restart it, it won't. Once I wait a few minutes for it to cool down, it will restart. I never know how long it run till it stops. A load last night stopped at...


I would say thermal fuse, here is a website that will tell you how to check, it also has other possibilities, Hope This Helps Tim:

http://www.partselect.com/dryer+dryer-wont-start+repair.htm

Oct 21, 2010 | GE Dryers

1 Answer

I have a tumble dryer.


Sounds as if the door switch is the problem. This is normally a safety switch that stops the dryer when the door is opened.
Unplug the dryer.
Remove the door switch and check the switch condition with a continuity meter after removing the wires. Try turning the switch on and off....the meter should read power on and off when you do that.
You may have to remove the front of the dryer to get to the door switch.
Good luck,
I hope this helps

Oct 05, 2009 | Hotpoint Dryers

1 Answer

Wont keep running.have to open door to restart every minute or so


YOU MIGHT HAVE A BAD DOOR SWITCH OR A BAD CYCLING THERMOSTAT OR THERMAL FUSES ON THE BRINK. DO THIS GO TO www.repairclinic.com ENTER YOUR MODEL NUMBER SCROLL ALL THE WAY DOWN AND CLICK THE RED 100 THEN LOOK FOR PARTS 2986 CHECK THI PART FOR CONTINUITY. THEN LOOK FOR THESE 2651 AND CHECK TO SEE IF THEY FUNCTION BY TAKING THEM OUT AND APPLYING A LIGHTER TO THE SENSING SIDE YOU SHOULD BE ABLE TO HEAR AND FEEL THEM CLICK. IF THEY DO THEY ARE GOOD. THEN LOOK FOR 898078 IF YOU HAVE IT OR 904589 EITHER A THERMOSTAT OR DOOR SWITCH IS BAD. GOOD LUCK

Apr 17, 2009 | Whirlpool LEQ8000JQ Electric Dryer

1 Answer

Kenmore Dryer model #66912690 The dryer stops


replace motor drive,,,defective motor...onthejob

Feb 08, 2009 | Kenmore 62602 Electric Dryer

1 Answer

Dryer runs for minutes then stops timer keeps going and going and .....


remove the vent on the dryer that goes to the outside start the dryer if it continues to ru n and not cut off you have a venting problem of the house

if it cuts off after 5 mins with the vent off you have a motor that is going bad

Jun 11, 2008 | GE DBXR463EBWW Electric Dryer

Not finding what you are looking for?
Hotpoint NBXR463EBWW Electric Dryer Logo

Related Topics:

166 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hotpoint Dryers Experts

Gerry Harvey
Gerry Harvey

Level 3 Expert

1456 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Chris Hall
Chris Hall

Level 3 Expert

842 Answers

Are you a Hotpoint Dryer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...