Question about Plumbing

Open Question

Repair Kohler k-6962-2

How do I remove the valve below the spout?

Posted by Anonymous on

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 34 Answers

SOURCE: Unable to pull spout to replace O'Ring in Kohler Faucet F10416

They just pull out, sometimes things get stuck and I cant get them lose as a plumber and you just have to buy a new one...dont feel bad

Posted on Feb 05, 2009

  • 68 Answers

SOURCE: Cannot pull out spout to replace o'ring of Kohler Faucet 10416

the pic u have up doesnt show it being a pull out u trying to fix airater?

Posted on Feb 07, 2009

buffalonyman
  • 1865 Answers

SOURCE: Replace entire valve assembly

You can drill a small hole into the set-screw and use an easyout to extract the set screw

Posted on May 07, 2009

  • 88 Answers

SOURCE: Kohler purist shower and tub diverter valve has

washer on back of diverter stem needs replacing

Posted on Aug 25, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to remove washer from 1 above


Kohler doesn't offer a lot of online help, but you might have a look at <http://www.us.kohler.com/us/static/helpTopicsHelper.jsp?helpId=559>.

Feb 12, 2015 | Kohler K-560-VS Bellera Bellera Pull-Down...

1 Answer

I have a Kohler kitchen faucet, model# K10416CP that is leaking around the bottom of the center ring just above the spout. It leaks very bad when we change the position of the spout. Can we fix this...


yes, remove the nut and lift the faucet up and out, you will see a rubber washer/o-ring that is like chewed up, at any home improvement center,hardware store or even a discount in there plumbing section they have faucet repair kits. Either take the old piece or the faucet and match it up, then reinstall and it will all be good. Good Luck Tim

May 22, 2011 | Kohler Plumbing

1 Answer

Upper O rings leak. How do I take the units apart to get at these rings on the handles and on the spout?


handles are secured with small allan screw in back.then the escutcheon unscrews,then valve stem unscrews,use a little plumbers grease when reassembling.spout collar un screws might be really tight, then wiggle wiggle spout while pulling up.grease o rings when reassembling.

Jan 28, 2011 | Kohler K-16109-4-CP Revival Kitchen Sink...

1 Answer

I've installed a newly purchased Kohler forte 10433-VS faucet but unable to get spray to fully engaged and seems to leave the partial spout running resulting in a in between or partial spray and spout. Is...


Sounds like the diverter is not working properly. It is located in the spout and it maybe sticking or bad. Go to link below for a installation guide with parts break down. Click on installer's and designer's bar below picture of faucet for a diagram of faucet that may help you out.

http://www.us.kohler.com/onlinecatalog/detail.jsp?from=thumb&frm=&module=Faucet+Collection+Kitchen&item=9559802&prod_num=10433&section=1&category=4&resultPage=0-711729362

May 31, 2010 | Kohler Model 10433: Fort® Single-control...

1 Answer

Replaced shower valve. still drips from tub spout


The cartridge has 2 or 3 o-ring type seals around it that feed the water through, it picks up both hot and cold and mixes them. Some cartridges are replaced as one, some you have to replace the seals, just take the faucet info to the hardware store and match it up. I think the diverter is for the shower. It sends the water up instead of out.

Feb 28, 2010 | Kohler K-9511-BN MasterShower Shower Arm &...

1 Answer

Re: soap dispenser of my K-R10430 Kohler 4-hole faucet. The small spout has started coming out of the body of the dispenser when dispensing detergent. Installation and homeowners guide don't show whether...


I'm not sure if it can be repaired or not, but lowes carries the same dispenser that came with faucet. To replace unscrew bottle from under counter now you remove plastic nut that holds the body to counter and install new one.

Sep 28, 2009 | Plumbing

1 Answer

Kitchen faucet


look under your sink there will be a big nut screw it up toward the counter top this will fix your problem also may want to look into getting a prv for your house this will lower your water pressur in your house

Mar 13, 2009 | Kohler Forte entertainment remote valve...

1 Answer

Unable to pull spout to replace O'Ring in Kohler Faucet F10416


They just pull out, sometimes things get stuck and I cant get them lose as a plumber and you just have to buy a new one...dont feel bad

Jan 31, 2009 | Kohler K-10416-BN Fort½ Single Control...

1 Answer

Cannot pull out spout to replace o'ring of Kohler Faucet 10416


the pic u have up doesnt show it being a pull out u trying to fix airater?

Jan 31, 2009 | Kohler K-10416-BN Fort½ Single Control...

Not finding what you are looking for?
Plumbing Logo

Related Topics:

35 people viewed this question

Ask a Question

Usually answered in minutes!

Top Plumbing Experts

Donni Steen

Level 3 Expert

659 Answers

Brad Brown

Level 3 Expert

15441 Answers

Tom Chichester

Level 3 Expert

33282 Answers

Are you a Plumbing Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...