Question about Harley Davidson Harley-Davidson Motorcycle Desktop Telephone

Open Question

Suzuki GSF 250 bandit CDI

My GSF 250 needs a new cdi.... igniter.
The one in it is a 32900-11D10. I believe it is for the 40hp model.
I havn't been able to find one ... I managed to find one for the 45hp model.
The 45hp one is a 32900-11D00.

Will this work? and what will the effects be?

Please help

Posted by on

  • dean12345 Oct 24, 2008

    Will a 32900-11D30 work?


1 Suggested Answer

  • 116 Answers

SOURCE: can i use any suzuki bandit 1200 cdi unit in my 97

doubt it

Posted on Jan 05, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

M/benz a 180 cdi pairing phone to radio

samsunge1175t dead problam sulation

Dec 13, 2013 | Lands Phones

1 Answer

The glass container leaks, I believe I need a new blade & seal, as the plastic part that has the blade is cracked

Hello. Generally you can order a new container, or you could repair it with a one minute clear epoxy. Generally I recommend that you replace it. regards, Joe

Dec 19, 2009 | Lands Phones

1 Answer

Need battery for cordless headset phone - model 2-9918A

I could not find the battery for your phone. But you may click this link and I hope this would help you:

I believe that any battery that has the same voltage output and same connector would work with your phone.

Apr 17, 2009 | Uniden Cordless Phone

1 Answer

Lost manual can i find one on line?if so how and where

U see to tel u frankly u wont need d manual unless u havn`t read it at all.... all u need to knw r d defaults (password if enabld ... hold value if applicable..)... if u really want dem u can easily get it online r a copy 4m yr dealer wud also suffice....

Apr 12, 2009 | Lands Phones

2 Answers

How to diagnos a motorcycle cdi

Hi and welcome to FixYa,

To my knowledge most motorcycle CDIs have multiple wires/connections. The pinout could have the following:
  1. 2-4 wires from the pulse trigger. This is normally located beneath the magneto or in some cases a crank sensor;
  2. IGN B+12 coming from the ignition switch;
  3. IGN coil's negative terminal. The coil's positive terminal goes likewise to the IGN B+12;
  4. interlocks:
  • sidestand switch;
  • neutral switch;
  • clutch switch;
  • RUN (Engine OFF) switch.
Good luck and thank you for using FixYa.

Feb 13, 2009 | Harley Davidson Harley-Davidson Motorcycle...

1 Answer

My sons Dr250 Suzuki's gear leaver shaft has slipped into the motor and has no gears, I can pull it back out to its original position to select gears, the question is what is supposed to stop the shaft...

I believe that on these models the retaining clip is internal,and the shaft seats into a bearing at the other end. If the bearing has come apart it will allow the shaft to slide in and out also. Drain and check the fluid for metal or excessive shavings. If it were external, you should be able to see the groove for the clip with the shaft pulled out. Most likely, you're going to have to pull the engine, and split the cases to get to the tranny in order to fix the problem. Pain in the arse, I know, I've done it a few times on my dirt bikes. Assuming this is the DR250 enduro style dirt bike I'm thinking it is. If I'm wrong on the bike type let me know, and I'll see if I can get more info, cause I believe Suzuki also made a DR 250 S in the late 80's or early 90's, which was a sport bike.

Aug 24, 2008 | Harley Davidson Harley-Davidson Motorcycle...

1 Answer

Im not getting any spark from one of side of my 2 cyclinder kawasaki ninja 500 EX. Its an 1987. I have replaced the plug wires and the pickup coils. I switched the coil packs and both work. Im just not...


To my knowledge, a 1987 Kawasaki EX500 uses a TCBI with digital advance to fire the ignition coils upon receipt of pulse from the trigger/pickup coils.

Since the pickup coils are new, and you have swapped the ignition coild, replace the high tension wires and checked/replace the spark plugs, the the only cmponent left is the CDI (electronic ignition system).

Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information.

Good luck and kind regards.

Thank you for using FixYa.

Jul 02, 2008 | Harley Davidson Harley-Davidson Motorcycle...

1 Answer

Ans/rls button...

I believe it indicates your in headset mode, and lights up when you do not have a headset button

Apr 30, 2008 | Samsung Prostar DCS Phone

2 Answers


Try other different searches. There are many manuals for different models. I don't know which is yours. If you let me know what the exact model(s) of the phones are. I'll try to get the exact manual(s) that you need. Try this one though. You can jus do the searches yourself, though. Just type the name and model in the search box like this.

For example:
<name><model number>
Lucent ny5443 (sometimes it works to add 'manual' and the end, sometimes not)

Mar 10, 2008 | Lands Phones

Not finding what you are looking for?
Lands Phones Logo

Related Topics:

361 people viewed this question

Ask a Question

Usually answered in minutes!

Top Harley Davidson Lands Phones Experts


Level 3 Expert

100387 Answers

Brian Mathews

Level 1 Expert

20 Answers

David Payne
David Payne

Level 3 Expert

14160 Answers

Are you a Harley Davidson Lands Phone Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides