Question about Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher
If you find the dish wash makes the noise like the draw has been open and its mainly at night you most likely have cockaroaches. The dishdraws have infared sensors to tell it that the draw is open which works like a beam of light. When the beam of light is broken the draw thinks its open. When a cockie runs across the beam it blocks the light and the draw thinks its open. Get a good qulity surface spray and spray right around the door as they enjoy living near the warm CPU board. Most people don't realise they have cockies there untill i pull the draw cover off and show them.
Posted on Feb 24, 2012
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
First is to make sure there is no leak. Pull out the lower tube, access from the left side only this side you can put your hand in with a small tower to dry out the wetness if there is. If it is wet dry out really good then unplug the power cord for 24 hr. After that plug power cord back. Hold the lock button while press the Start button until you see a display appears. Press the Power button to see a clear display. Then hit Start button one by one until you see Ld ( it stands for Lid down) If you miss it, keep going until it comes back in a loop. When at Ld hit the lock button. Wait until the noise is stopping. Hit the lock button again. Wait until the noise is stopping. Now you can pull out the top drawer and press the power button to get out this manual mode. Good luck.
Posted on Dec 29, 2009
Fisher Paykel dishwasher repair video, this video will walk you through repairing your dishwasher.
Posted on Feb 26, 2011
The controllers get very brittle & can break away from their housing, the reason it's rapidly beaping is because it thinks the door is open. PLEASE TURN IT OFF FIRST AT THE POWER POINT. Take the front draw panel off by pulling the plugs situated on the front behind the draws, the controller is at the top right hand side if it is loose then thats the problem, double sided tape will work but lots of it or try a wedge type arrangement. I know this is an old post but people refer to these for solutions much later.
Posted on Nov 30, 2011
Tips for a great answer:
Dec 12, 2015 | Fisher and Paykel GWL11 Top Load Washer
Aug 20, 2014 | Fisher Paykel 24 In. Panel Ready Double...
Feb 01, 2013 | Fisher and Paykel GWL11 Top Load Washer
Jan 28, 2013 | Fisher and Paykel GWL11 Top Load Washer
Jun 11, 2010 | Fisher and Paykel GWL11 Top Load Washer
Feb 09, 2010 | Fisher and Paykel 23 in. DD-603SS Built-in...
Mar 09, 2009 | Fisher and Paykel 23 in. DD-603SS Built-in...
134 people viewed this question
Usually answered in minutes!