Baby Gear Logo

Related Topics:

A
Anonymous Posted on Feb 09, 2012

How to fit a my child remi car seat . - Baby Gear

3 Related Answers

Anonymous

  • 286 Answers
  • Posted on Mar 21, 2011

SOURCE: Fitting instructions for Britax First Class SI

hi here are the uk instructions if you need a different country please comment back with your country and i will get back to you

http://www.britax.co.uk/media/143820/9.pdf

Ad

Anonymous

  • 5 Answers
  • Posted on Aug 11, 2010

SOURCE: can a baby-start remi car

Stores had recalled a Remi 2 Travel Basic Car Seat as a precautionary measure.There is a risk that the car seat may not provide the required restraint if the seat straps can be removed and then rethreaded. However this seat should strap in with the lap strap.

oddduck

  • 35 Answers
  • Posted on Mar 11, 2011

SOURCE: How to fit the straps on a Britax Freeway childs

Page 3 of the user manual explains how to configure the harness straps.

http://www.babys-mart.co.uk/videos_and_guides/user_guides/Britax_Freeway_user%20guide.pdf

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

My granddaughter is needing to be facing forward now and i am trying to locate anchor points in a 2000 dodge intrepid so the seat can be installed properly

Bolting in child seats is rather old fashioned since a range of child seats arrived on the market that are designed to be retained by the vehicle's own seat belts.
These seats are easily swapped between vehicles, are safe and secure and widely available.

I haven't needed to bolt in a child seat for nearly 20 years but I used to fit many for my customers. It was invariably impossible to piggyback the upper strap mounts onto the vehicle seatbelt anchor points and new mounts had to be drilled after removing seats and trim. Sometimes it was possible to piggyback the lower mounts. So far I haven't encountered any car with pre-installed child seat mounts.
0helpful
1answer

Peugeot 307 estate wagon

In the outer rear seats, you may use either the ISOFIX attachments or the seat belt. In the center rear seating position, you may only use the seat belt.

Carefully read the instructions for your child seat and the vehicle manual. They will give you directions to install your child seat properly.
Oct 06, 2013 • Motorcycles
0helpful
1answer

I need to know where to find the child anchor for a 1996 dodge caravan

There are no child anchors on a 96. This was around the time the latch system was under development. Just went through looking into this for my 1996 van. chico car seat fit well

The newer van seats will not fit either( I do have a 2007 seat for sale now ) as I tried to make one fit in my 1996 van with the latch system and it didnt fit. Wheels right spacing too wide for the anchor points.
Tom K. MN

I’m happy to help further over the phone at https://www.6ya.com/expert/james_da451a4ec470352a

0helpful
1answer

I have a peugeot 206, 3 door, i am looking for a car seat to fit into the front seat, the baby is 3 months, i would like one to go up to 4 years

hi have you tried the britax website
http://www.britax.co.uk/car-seats/fit-finder

they will find one that fits and suits the age of your child
Oct 29, 2010 • Baby Gear
0helpful
1answer

I have a 1990 toyota camry. the rear seat belt doesnt seem to hold my childs car seat. seat belt does not lock. both rear seatbelts are the same. Any ideas?

the camry does NOT have the type of belt you require.only answer is replacements or change the child seat to one that fits the anchorages.
0helpful
1answer

Can a baby-start remi car seat be fitted in the car with a lap strap

Stores had recalled a Remi 2 Travel Basic Car Seat as a precautionary measure.There is a risk that the car seat may not provide the required restraint if the seat straps can be removed and then rethreaded. However this seat should strap in with the lap strap.
Aug 10, 2010 • Baby Gear
0helpful
1answer

Car seat in Rear Facing Position takes up too much room in our car. Any suggestions.

We have 6 car seats for our 3 children; one in each vehicle. I moved the seats around so all three can fit in our CRV; however, if I would not have swapped the carseats, all three would not have fit in the CRV. In other words, be creative. When your child is old enough/big enough for a booster seat, those are smaller. I think I waited until my child was at least 3 for a booster, but they are worth the $30-$60 to save the room you need in the car if your child is big enough.
0helpful
5answers

Child car seat - unable to put it back together after washing

You need to pass the belt behind the sit.
Mar 21, 2009 • Baby Gear
0helpful
2answers

How do I install a child seat in a 1998 toyota corolla?

as long as you have the sealtbelt properly fitted on the childs chest. there wont be any problems. btw, i have a 1979 toyota corona. so that makes our cars nearly the same.
Mar 24, 2008 • Baby Gear
Not finding what you are looking for?

302 views

Ask a Question

Usually answered in minutes!

Top Baby Gear Experts

Jennifer Rock
Jennifer Rock

Level 2 Expert

153 Answers

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Are you a Baby Gear Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...