Question about Gateway Belkin 54g Wireless DSL/Cable Router (DHF5D72304)

1 Answer

T! lines How do you install a T1 line.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 56 Answers

A T1 line is a dedicated connection to an Internet backbone router. Typically a T1 line is for major businesses and school campuses. A T1 line is capable of handling 637 simultaneous VOIP connections with full-duplex connection.

How many computers do you intend to have connected to this network? Even a fractal T1 is very expensive. A full T1 connection can cost nearly 25K per month usage. A T1 line will need to be installed by your ISP provider and this too will cost a significant amount of money and it depends on how close your network connection will be in relation to the main network trunk-line.

If you trying to connect a T1 line to a Belkin 54g wireless router, you are way out of your league. I have worked for several networking firms in the Atlanta, GA area and we never had more than a fractal T1. Most small to midsized networks (up to 100) users can be accommodated with using a DSL or Cable Internet connection with a dedicated firewall and router/switch to handle the network traffic. Unless you are willing to pay for a T1 fiber optic line to be run from the main trunk line to your place of business or home, you will be fine with a high speed cable internet connection from an ISP provider like Comcast of Qwest here in the US. Fiber still has an installation cost of about $10,000USD per 1000 feet.

Hope this helps to clarify your problem.

Cheers,

Keith

Posted on Oct 23, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a nortel tasman 1004 with 1 t1 port licensed. I need to have it reconfigured to a new location with new ip address and updated software if possible... I have tried to program it myself and keep...


Here are some commands to configure your tasman router :
tasman> sh configuration runn Please wait... (up to a minute)

terminal exit terminal qos exit qos module t1 1 clock_source line alarms thresholds exit thresholds exit alarms linemode exit linemode exit t1 module t1 2 clock_source line alarms thresholds exit thresholds exit alarms linemode exit linemode exit t1 interface ethernet 0 ip address 66.201.12.x 255.255.255.0 <------- for example ip multicast ospfrip2 icmp exit icmp qos exit qos vrrp_mode 0 exit ethernet interface ethernet 0.1 ip address 62.18.3.0 255.255.255.0 <------ for example ip multicast ospfrip2 icmp exit icmp qos exit qos vrrp_mode 0 exit ethernet interface ethernet 1 icmp exit icmp qos exit qos exit ethernet interface bundle MFR1 link t1 1 link t1 2 encapsulation frelay fr intf_type dte frame_size 4470 mfr fragment_size 4000 mfr seg_threshold 3999 lmi ansi exit lmi pvc 500 shaping cir 3072000 bcmax 3072000 bcmin 65536 no policing ip address 15.10.16.86 255.255.255.252 <------ WAN IP address to ISPicmp exit icmp red exit red exit pvc exit fr icmp exit icmp qos exit qos exit bundle aaa radius exit radius exit aaa snmp system_id tasman1 enable_trap exit enable_trap exit snmp hostname tasman telnet_banner exit telnet_banner event exit event system logging syslog exit syslog exit logging ip load_balance per_flowroute 0.0.0.0 0.0.0.0 15.10.16. 85 1exit ipfirewall globalalgsexit algsmax-connection-limit self 2048exit firewall firewall internetexit firewallfirewall corppolicy 1024 out permitexit policyexit firewallpolicy community_list exit community_list tasman>

Or use the link below:http://www.ipbalance.com/vendor/tasman-networks/454-mlfr-boundle-serivce-configuration-for-tasman1004-router.html

Dec 04, 2011 | Nortel Networks SR1004 4P ACTIVE T1 ...

1 Answer

T1 wireless router


Unless there is already a wireless router connected to T1 line in your building then yes, to use wireless off the T1s connection, you would need to add one in.

Apr 06, 2010 | Routers

1 Answer

Can't connect Dell TrueMobile 1184 with Adtran NetVanta 3200


It sounds like you need to "crossover" the connection.

Using a crossover patch cable to connect the two devices is the first thing that comes to mind. (http://en.wikipedia.org/wiki/Ethernet_crossover_cable)

However, some routers/switches have physical buttons on ports to cross them over or you can use their web-based management to change port settings.

I hope this helps.

Jan 27, 2010 | Adtran NetVanta 3305 Router

1 Answer

Avaya 5420 phone system


There is a problem with the trunks. A phone line could be bad, a line (PRI/T1) could be dead....

Jul 02, 2009 | Avaya - IPO-56/5400 SETS(IU).IP PHONE 5420...

1 Answer

Router not responding to http request


possible firewall on the router check settings make sure its not blocking ping requests everything else works?

Jun 05, 2009 | Cisco (1841) Router (cisco1841)

1 Answer

Cctv remote view/ adtran total access 900e


It's not likely that VZ gave you dynamic IP's, but it's possible. You should have been given more than one. If not, it's better to get more and a set of configuration instructions. In the last one I set up, we put a 5-port switch on the ethernet port coming off the Adtran, then fed 2 routers and a security system from the switch. Our gateway was one number lower than the bank of IP's we had, and we just gave each piece of equipment a static ip address and gateway to the gateway :-)

Carl

Sep 19, 2008 | Routers

1 Answer

Disconnection problem/on&off dsl


a modem is designed to run 24/7 on the chips in factories they run them in abnormally hot and cold conditions for days on end to see if they can stand up to long term use and in different conditions but you have nothing to lose if you turn it off every now and then except your internet and or phone line

Jun 27, 2008 | Zyxel P-660RU-T1 ADSL Ethernet/USB Router...

1 Answer

Going wireless with a T1 Line


Going wireless should not be influenced by the nature of your internet connection. Here, I will assume that your definition of "standard router" is the kind of router we can buy at any electronic store (DLink, Linksys). I you are think more about a high end router such as a Cisco 2600 or 2800, please post a comment and I will adjust my answer.

If you already have internet access through your T1 using a wired network, you may just add one (or more) Wireless Access Points to your existing network. No need for a router here since you already have one for connecting the wired network.

On the other side, if your T1 line will be dedicated to your Wireless access, then a router should do the job. Usualy a T1 line uses a static IP address on the WAN side. If your Wireless coverage required more than one Access Points, then I would suggest you to use a standard router (no Wifi) with seperate access points.

Apr 20, 2008 | Routers

1 Answer

Point to Point T1 Using Cisco 2800 Routers?


Are you trying to set up router ?
You can set up your router manually, without the CD.
Make sure that your computer is able to go online directly through the modem.
If your computer is able to go online through the modem, that means the modem is working fine.
You will need to connect the computer to the router and the modem to the router.
open the set up page of the router and change the settings of the router according to the ISP.

Dec 03, 2007 | Cisco (WS-X3011) Router

2 Answers

I can't get pro evolution to work with my 660RU-T1 router


can you chk if you can open DMZ in the router ? This shud help. Ping me back if it still doesnt work

- Ranjit
ranjit@supportminds.com

Nov 16, 2007 | Zyxel Prestige 660R Router (91004397002)

Not finding what you are looking for?
Gateway Belkin 54g Wireless DSL/Cable Router (DHF5D72304) Logo

Related Topics:

127 people viewed this question

Ask a Question

Usually answered in minutes!

Top Gateway Routers Experts

Steve

Level 3 Expert

3287 Answers

k24674

Level 3 Expert

7987 Answers

Justin
Justin

Level 3 Expert

2072 Answers

Are you a Gateway Router Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...