Red diagonal spottted lines

db:: 4.31::Diagonal lines on tm2 screen? fz - Hivmr

www.hivmr.com/db/fzap9jk8dp87mcjk3cc9jsp7fzxk7pz1

There are faint 45 degree diagonal lines covering my brand new tm2 LCD ... with some static looking diagonal lines going from bottom left to top right. .... DB:3.01:Dv6113 Us - Computer Freezes Showing Diagonal Lines On Screen aj ... Also there arediagonal lines that run across the screen at about a 30 degree angle.

3M Privacy Filter for Laptop diagonal-14.1" viewing screen ...

www.amazon.com/3M...diagonal-14.../B00006B8A9

Amazon.com, Inc.
Rating: 3.8 - ‎1,617 reviews
Amazon.com: 3M Privacy Filter for Laptop diagonal-14.1" viewing screen ... Premium 14.0 Inch Privacy Screen for Widescreen Laptop or Computer Monitor .... 3M™ Privacy Filters create a 30-degree cone of vision so on-screen data is .... You'll also notice a large "3M PF14.1W" printed in the top right hand corner of the filter.

FZ190: Faint Diagonal lines on screen? ' NotebookReview

forum.notebookreview.com > ... > VAIO / Sony

There is something wrong with your recording heads. TAKE IT BACK.!

The panel is almost certainly bad. The only fix for this is to replace the whole panel which would cost more than the whole TV.

puzzle 130:Assuming on a chess board 8x8 that each square is numbered 1-64 top left to right.Place a queen on each of these squares 3,13,18,32,33,47,52 and 62 bobs yer uncle

Can be 1 of 2 things. 1st the red tube just needs the voltage to it turned down. In the front of TV (you have to remove the lower front half of TV to access it) is a plastic square with 6 knobs. The from left to right top knobs control focus for blue,green red. The bottom knobs control voltage to each tube in same order (so lower right knob for red) turn SLOWLY to left to reduce voltage until excessive red and lines go away. If you over turn left or right set will turn off. If that does not fix it or if lines reappear then option 2 is that red picture tube is failing outright and needs replacement.

it can be a picture tube problem. moreover, check if your tv is dusty inside it . clear it with blower and try again.


regards,

mmmmm

Sorry, that is common for generic replacement xformers for
your make / model . There are some adjustments to minimize
the effect in servicer menu...............you can try turning down the
screen control a bit....................T.

sample of a line diagnally from bottom to top of page.

Hi.

Just read your list of problems The first fault (Diagonal lines & picture collapse from left & right) Sounded like either A poor connection or dry solder joint either on scan coils or scan coil plug / socket on main pcb.
If this were the case the engineer that called out should have spotted this & sorted it very easily. But you say it is still the same so what did he do ?
Did he give you a reciept with break down of what he did ? If yes please post it here for me to go over.

The sound problem you describe has thrown me a little so could you please post your tv model number on this page so I can see if this is a stock fault.

The static shocks you are getting is relatively normal & not a problem unless you are getting them off of speaker grilles or even tv casing if it is silver in colour.
I am UK based & have access to samsung technical but I will need your tv model number.

http://dysonmanuals.inc.io/

Chris.