Question about Motorola Phones

1 Answer

Cell phone baattery will not hold charge batt # bz60 phone bought 3-22-08

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Motorola Master
  • 19,396 Answers

You need to replace the battery, if the phone is less than one year old, call the phone number listed on the phone owner manual, and see if the cost can be covered.

Posted on Oct 22, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The phone has a new battery, it is not charging and beeps continually, what do I need to do for it to hold a charge?


The EnGenius phones cannot use alkaline batts. Clean the phone, batteyr and ALSO the contacts inside the charger. If still not charging, buy a new charger.

Oct 01, 2014 | EnGenius Phones

1 Answer

I just bought another handset (DCX150) to use with my Uniden DECT1580 phone and cannot get it registered for use. The phone is completely charged but after holding down the # key for 30 seconds (as...


I had the same problem with the same equipment and I found this on the web. It worked well for me.
* Remove the base unit's phone from its cradle.
* Unplug the power from the base unit.
* press and hold the FIND button on the base unit, then, while continuing to hold down the FIND button, plug in power again. The CHARGE light should then be flashing. You can release the FIND button.
* press and hold the # (pound) key on the accessory phone you are attempting to register to the base unit and hold this phone OVER and NEAR the cradle/charging prongs until the phone goes through the registration process. (again, don't set the accessory phone in the unit, but just hold it near the unit).

Good luck!

Sep 11, 2010 | Uniden DCX150 1.9 GHz 1-Line Cordless...

1 Answer

I charged all batt one hand set does not work.i tried to charg the other one but no luck


If the phone is still under warranty, take it and the offending handset group back for exchange; otherwise assume you have one or more dead cells in the pack. To verify this swap out battery packs to see if the phone they were transferred to works. If it works leave 'em in for a while and check again. Using the phone will cause a heavier drain on the batteries. Is possible the unit may need replacing.

Hope this helps.

Sep 16, 2009 | Uniden 5.8GHz Dual Cordless Phone

1 Answer

Uniden XS 1210 cordless phone won't connect to base unit


try connecting both phones via the base that is working and see if they recognize each other. Let me know if that works.

Jul 21, 2009 | Uniden Cordless Phone

1 Answer

Phone will not hold a charge and there is static on phone


Those phones always have problems. Call the manufacturer and have them replace the problem phone(s).

Jul 15, 2009 | Vtech 5.8GHz Cordless Phone with Digital...

1 Answer

Phone wont connect to verizon. message on phe says place set in


Unplug main unit and the other unit which is not working then plug back on after few minutes. If its still the same then change battery on hand set. baattery life is only four years

Mar 26, 2009 | Vtech 5.8 Ghz Handset Cordless Phone...

1 Answer

My sn920 will not hold a charge


You can contact your carrier and they will manually call forward your number.
Cheers.

Mar 18, 2009 | EnGenius SN 920 Ultra Cordless Phone

7 Answers

Motorola E815 has been paired with VRBT300V Bluetooth


I just bought this unit today at Costco.  I read a post on yahoo that said to make sure that you hold the on button long enough to see the blue and red lights flashing.  Once I did that my cell phone had no problems finding the unit.

Jun 29, 2008 | Phones

1 Answer

Phone holds charge from 12-55 min. and then goes dead


Your handset or charger has gone bad (provided you installed rechargable batteries), or both. The previous user may have installed alkaline batteries (is their a white powdery residue in the the charge compartment?), and that can ruin the charge circuit. Either way, you probably need to contact repair. You can go to www.cordlessrepair.com

May 23, 2008 | Siemens Gigaset 4000 Phone

3 Answers

Motorola MD760 dies after 5 minutes of use-- from being charged for days on base


this is a battery prob replacing battery will solve this prob hope this solves your prob make sure the battery connectors are conected propery securely first before replacing if ok then replace batt and prob should be solved check then conectors are clean where the phone sits on base and check phone sit on base properly if it does then it is def the batt replace.

Nov 15, 2007 | Motorola Mobility MD761 Cordless Phone

Not finding what you are looking for?
Phones Logo

Related Topics:

79 people viewed this question

Ask a Question

Usually answered in minutes!

Top Motorola Phones Experts

Cindy Wells

Level 3 Expert

4757 Answers

David Payne
David Payne

Level 3 Expert

13437 Answers

SSN-MM3

Level 2 Expert

54 Answers

Are you a Motorola Phone Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...