Question about Combination Televisions

1 Answer

Kawasaki electronics I'm looking for a different part for a Kawasaki LCD tv, but I can't find a web site!

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Kawasaki has been using their good name on electronics ie tvs dvd players... But this is just a trademark and kawasaki has nothing more to do with these products other than renting their name out. Alco Electronics is the company behind them 1800-252-6123

Posted on Mar 08, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Codes for toshiba tv


They are SPECIFIC to each model. Look on the Toshiba web site

Jul 23, 2014 | Combination Televisions

1 Answer

AWA HD LED LCD TV with builtin DVD Manual


Hi Beverly House

You can use this manual for your LCD TV
http://download1.medion.com/downloads/anleitungen/bda_21097_uk.pdf

I hope my solution may help you.
Thanks for using Fixya...;-)

May 06, 2014 | Combination Televisions

1 Answer

PROMAC LCD TV in Standby Mode


Check the remote control for its infrared emission. Without remote control, you can't set it out of standby. If you wish to get more details, check this site. Pull up older posts there. Check the site with patience, as it has over 2350 posts now. All are related to electronic equipment repair help. There is one post have details about how to check and repair remote controls. http://electronicshelponline.blogspot.com/

Apr 23, 2013 | Combination Televisions

1 Answer

Black tv screen with line across


Vertical output IC has failed. It should be replaced. You haven't given the brand name and model number here. I assume that it is a Toshiba TV. If so, Visit this site for more details. Type in the site name "Electro-help" either Google or Yahoo search box [not in the address bar of your browser], and click search. It is an electronic equipments service help site. All details you want are there. Note the position of hyphen in between words in site name, when you type it in. The site will appear as it is in web; subtitled as service help to electronic home entertainement equipments.

Pull up older posts. You can gather all details. Sometimes, clicking on the ads by the side and bottom of each post might give you more details.

Pull up older posts.

May 28, 2012 | Toshiba MW27H63 27" TV/VCR/DVD

1 Answer

Got a jumbo remote and lost my codes got a sylvania tv and need codes


Look in the directions for the remote; it should tell you how to have the TV scan for the right code. Or the directions may have a code for you to enter for your particular TV, it depends. Otherwise, go to the web site for the remote. You will need your TV make and model number. Got that?

Jun 11, 2009 | Emerson EWC19T3 19 in. TV/VCR/DVD Combo

2 Answers

Sound but no picture on polaroid television


It is the inverter for the LCD I have the same problem the inverter pt# is UI8007S-1 and they sell on EBAY for 58.00 but I found a web page that will give instructions and a plave in Canada that the person that posted says it should cost about 20.00 I removed the inverter and it has a burnt chip just like the article said. Good Luck!

Dec 30, 2008 | Polaroid FDM-0700A 7 in. TV/DVD Combo

1 Answer

No picture will talk, picture dark


If you mean you have nothing on the screen, either the backlight or its associated power supply has faiiled. Look at the screen at several different angles; if you can see some sign of motion, then the LCD panel itself is still ok.  

Nov 06, 2008 | Sansui LCDVD200 20 in. TV/DVD Combo

3 Answers

KAWASAKI LCD TV + DVD / UNIVERSAL REMOTE CODES?


use an LG or Goldstar Code for remote code.
per the manufacture 1/1/09 at 2:03 pm est

Aug 09, 2008 | Combination Televisions

1 Answer

TV won't turn on, timer LED flashing


If the TV goes in standby, then it is in protection mode.

Ensure also that the fault is not coming from a faulty receiver box sending
bad signal, check if you get same problem on DVD with no receiver box
connected.

Try first leaving the TV power cord unplugged for some times, let say one hour or so.

The flashing light indicates a diagnostic state called protection.
When the TV goes on protection there are only two possible causes.

1The internal circuits are jammed because of electrostatic charges accumulating on capacitors, or because of a wrong voltage read by the main chip on your monitor controller board. this started the protection circuit.

2 The protection circuit detected a wrong voltage or abroken contact, identified an internal fault and kicked in , starting the flashing light.

If you are in situation one, then the TV will reset just unplugging power cord for one or two hours,sometimes even minutes.

If you are in situation 2 , then there is an internal fault.

If under warranty contact the manufacturer ringing the number on the user manual

If you want to repair at your own expenses, just locate any good qualified repairer.

If you want to DIY you find parts here,

All: Appliance parts, electronics parts & more from PartStore.com

Encompass Parts Distribution

LCD/Plasma Electronic Replacement Parts: Plasma & LCD TVs, Appliances |


On LCD Pay particular attention at inverter and power board, power board can be inspected looking for bulged or leaking capacitors, then tested with a multimeter. The inverter is more difficult to test , there is need to read voltages, should be done by a tech. Also the LCD controller board can cause same problem

On Plasma, test Sustain (Ysus/Zsus) / Buffer boards , cables to plasma, digital board and power board.

On Rear Projection : check lamp, lamp ballast, power board, and convergence.

On CRT TVs, check ballast , flyback transformer, CRT, Tuner, Convergence.

Dec 19, 2006 | RCA T25061GY 25 in. Combo

1 Answer

The on timer is flashing and the TV will not come on. It is a TV VHS combo set. How can I reset this timer so the TV will turn on? Power down and back on does not help. Thanks,


If the TV goes in standby, then it is in protection mode.

Ensure also that the fault is not coming from a faulty receiver box sending
bad signal, check if you get same problem on DVD with no receiver box
connected.

Try first leaving the TV power cord unplugged for some times, let say one hour or so.

The flashing light indicates a diagnostic state called protection.
When the TV goes on protection there are only two possible causes.

1The internal circuits are jammed because of electrostatic charges accumulating on capacitors, or because of a wrong voltage read by the main chip on your monitor controller board. this started the protection circuit.

2 The protection circuit detected a wrong voltage or abroken contact, identified an internal fault and kicked in , starting the flashing light.

If you are in situation one, then the TV will reset just unplugging power cord for one or two hours,sometimes even minutes.

If you are in situation 2 , then there is an internal fault.

If under warranty contact the manufacturer ringing the number on the user manual

If you want to repair at your own expenses, just locate any good qualified repairer.

If you want to DIY you find parts here,

All: Appliance parts, electronics parts & more from PartStore.com

Encompass Parts Distribution

LCD/Plasma Electronic Replacement Parts: Plasma & LCD TVs, Appliances |


On LCD Pay particular attention at inverter and power board, power board can be inspected looking for bulged or leaking capacitors, then tested with a multimeter. The inverter is more difficult to test , there is need to read voltages, should be done by a tech. Also the LCD controller board can cause same problem

On Plasma, test Sustain (Ysus/Zsus) / Buffer boards , cables to plasma, digital board and power board.

On Rear Projection : check lamp, lamp ballast, power board, and convergence.

On CRT TVs, check ballast , flyback transformer, CRT, Tuner, Convergence.

On your VCR combo also ensure that there is no tape inside the VCR.

Dec 07, 2006 | JVC TV-20241 20 in. TV/VCR Combo

Not finding what you are looking for?
Combination Televisions Logo

Related Topics:

550 people viewed this question

Ask a Question

Usually answered in minutes!

Top Combination Televisions Experts

The Knight
The Knight

Level 3 Expert

68301 Answers

matt martin
matt martin

Level 3 Expert

1191 Answers

Jaime Hernandez

Level 3 Expert

2267 Answers

Are you a Combination Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...