Question about GE 27GT616 27" TV

4 Answers

Tv no start up, fuses ok.

There is no power , no noise, even no click when push the power button

Posted by on

  • 2 more comments 
  • JO cat Jan 03, 2008

    Won't turn on No noise whn pushing the button Nothing happens

  • japerdd Jun 03, 2008

    The TV (CT-26wx15N) was working fiine. Turned it off to take the kids for a walk when we got back nothing. The power will not come on - it is plugged into a surge protector and everything else is working fine, even tried changing outlets and plugs - it just quit. The TV is not even 2 1/2 years old.

  • Anonymous Jul 03, 2008

    I have a sony KV35v35. I watered a plant that was on top. The next day I found water on the floor...OPPs! Some probably went into the unit. A week later I tried to turn it go. I unplugged it for an hour, no go. Is there a fuse inside that I may want to look at or is there a common problem/fix for water. Maybe only a 1/2 cup went in but it has dried for 3 weeks and no go. Any ideas. T hanks. Rob

  • rschneirov Jul 13, 2008

    I have a 31 inch Toshiba less than two years old. After watching a movie the night before, I tried to turn it on and nothing happened. There is a light in front. It is getting power. But, there is no sound of the set turning on or a picture. There was no storm the night before.



4 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Telling someone to get professional help would be the obvious response from a TV repairman who wants to charge someone at least half the cost of TV replacement to fix it. People get on here so the can try and avoid the high cost of tv repair. How about giving advice on how to fix it which is why the got on here to begin with.

Posted on Dec 28, 2007


Defective capacetor or diode or regulator ic transistor

Posted on Nov 23, 2007

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert whose answer got voted for 500 times.

  • Master
  • 3,130 Answers

PRAVIN Its a ctc185 chassis would you invest a dime into a 15 year old set???LMAO

Posted on Jul 28, 2006

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.


    An expert who has written 50 answers of more than 400 characters.


    An expert who has answered 200 questions.

  • Expert
  • 275 Answers

Dear Cuba, I have said to everyone, repairing a TV is not a job for a handyman with Home or Garage tools. Problem could be a simple one like like a defective mains cord (very rare) to a blown Switching transisator in the SMPS or even a defective Horizontal Output Transistor or FBT... I can think of more possibilities.... Best Advice - Get Professional help.

Posted on Jul 28, 2006

2 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

  • 3130 Answers

SOURCE: tv no start up, fuses ok. chassis no. ctc185ab

WOW thats an old set man!!! Its not worth even getting an estimate for, as if your not a tech my advice would be, Dont play what can kill you!!!n its time to put this puppy to sleep my friend. Buy a new one!! Good luck

Posted on Jul 28, 2006

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2001 ford focus se clicking noise from fuse box dome lights flicker ignition clicking too,.... fuse?

Ok let's start here since I cannot see or hear your description a few things I need to know ok 1 is there an aftermarket remote start or alarm on this car 2 I know there's a fuel pump relay in the trunk I believe by the side that u fill up on pull back the carpet cardboard and see if it has tripped all u do to push the red button down if it's popped up let me know and we will get u going down the road agian thanks for your question look forward to handling this problem with you regards Chris ...

Mar 03, 2014 | Cars & Trucks

1 Answer

My he2t kenmore front load washing machine won't power on and there's a clicking noise

Vicki, i think that clicking sound is ok when you press start. TRY THIS.
1. close door securely 2. press power after putting detergent.3 After making your selction for different levels eg hot,warm cold, press START.
usually these buttons are pretty reliable, GL

Jan 12, 2014 | Kenmore Front Load Washer

1 Answer


if the lamp has gone the bottom light will flash if the top flashes there a problem with the tv there is reset you can do
  • Point the Sony remote control at the TV and press and hold the "Up" arrow button.

  • 3

    Push the "Power" button on the TV while holding down onto the "Up" button. Release the "Up" button when the TV turns off, then turns back on.

  • 4

    Select "OK" when shown the factor settings and the television has completed its TV reset

  • Read more: How to Completely Reset a Sony TV with a Blinking LED ' good luck regards shaun

    Dec 05, 2010 | Sony Grand WEGA KF42WE610 42" Rear...

    1 Answer

    Starter clicking noise, bike won't start

    start relay should be checked, if cables are loose or corroded they do not deliver enough power.if jumping the start relay will engage the starter replace the relay.

    Apr 29, 2010 | 2005 Honda VTX 1300 R

    1 Answer

    My Magnavox plasma screen tv, model number: 42MF237S/37 makes a clicking sound when I try to turn it on. No sounds, no picture, just the clicking noise. Things I have tried so far: 1) Turning the TV off...

    You either have a cold solder joint in your horizontal deflection circuits or your or in your horizontal output circuit. please be careful due to the fly-back transformer still holds power even unplugged until you discharge it.( ground it out). Hope this helps.

    Jan 03, 2010 | Philips Magnavox 27MS343S 27" TV

    1 Answer

    My big screen tv

    Those are the two 5amp pico fuses that go out when the convergenec Ics go out on a mitsubishi. You can get the ICs and pico fuses at the following link. If youre not sure which ICs you need leave them a email with your model nuber.Heres the link

    Sep 01, 2008 | Televison & Video

    2 Answers


    On some models the reset is unplugging for a minute or two and plugging back up. Otherwise you have a blown fuse where the power goes in. If you decide to replace the fuse do no go over 5 amps. If the replacement fuse blows there is a short in the set and needs a repairman.

    Jan 02, 2008 | Philips 19PR19 19" TV

    1 Answer

    Tv no start up, fuses ok. chassis no. ctc185ab

    WOW thats an old set man!!! Its not worth even getting an estimate for, as if your not a tech my advice would be, Dont play what can kill you!!!n its time to put this puppy to sleep my friend. Buy a new one!! Good luck

    Jul 28, 2006 | GE 27GT616 27" TV

    Not finding what you are looking for?
    Televison & Video Logo

    Related Topics:

    397 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top GE Televison & Video Experts

    The Knight
    The Knight

    Level 3 Expert

    74999 Answers

    Computer Repairing
    Computer Repairing

    Level 3 Expert

    14641 Answers

    Donald DCruz
    Donald DCruz

    Level 3 Expert

    17130 Answers

    Are you a GE Televison and Video Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides