Question about Health & Beauty
How to reset my scales? It doesn't matter who gets on we all weigh 150.1. It also has a new battery. THanks
Wexem,,,, thank you. Your instructions worked like a charm. Sad that the manual doesn't mention or contain reset instructions.
Posted on Mar 26, 2017
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
This is a reply I received from Taylor customer support. I have followed this procedure enough times to wear out the original battery and still get the Err 1 message. You may have better luck.
Thank you for your e-mail. The reboot below may clear the error from
your scale. You may need to do this several times to completely reboot
the system. Please let us know if you have any questions or continue to
display the Error.
1. Remove the battery from the scale
2. Set the scale on the floor without the battery in place.
3. Stand on the scale for 10 seconds (still without the battery)
4. Carefully replace the battery without turning the scale on.
5. Using only one foot, tap the scale or apply just enough pressure to
turn on the display. (It should show dashes or zero's) IMMEDIATELY
REMOVE YOUR FOOT.
6. Let the scale turn off
7. Step on the scale for a weight reading
Taylor Precision Products
& Salter Housewares
2220 Entrada del Sol, Suite A
Las Cruces, NM 88001
Toll free - 800-289-0944
Direct - 575-526-0944 ext 3172
Posted on Jun 24, 2009
I got it! Press "set". You should see "start goal" in the bottom right. Press the user # you want to save as and press "set" again. The display will blink then display "0.0". Step on the scale to get your current weight. Once it's read you current weight, press "set". A goal weight will display. Press "User 1" to make your goal weight go up and "User 2" to make it go down. Press "set" when the display shows your goal weight. That's it. Now all you have to do is press your user # and wait for "0.0" to display before stepping on the scale.
Posted on Mar 26, 2010
SOURCE: Error message ErrL
My scale had the same problem. I replaced the battery, but still got the same message. My wife noticed that one of the feet on the bottom of the scale was loose. The feet are twisted on to the scale and held by two small flanges. When I gently pulled the loose foot away I noticed that a small black wire had broke. I used my fingernails to remove a small bit of the wiring cover and twisted the ends back together. I then hide the wires back in a recessed area on the foot and placed it back on the scale. Worked just like the day I got it. Hope this helps!
Posted on Feb 20, 2009
Tips for a great answer:
Oct 11, 2013 | Homelite Garden
Apr 16, 2012 | Health & Beauty
Jan 15, 2011 | Jobar International Ideaworks Remote Read...
Jun 02, 2010 | Health Solutions LED Display Digital Scale...
Dec 01, 2009 | Health & Beauty
14,190 people viewed this question
Usually answered in minutes!