Question about Panasonic CX-DP801 8-Disc CD Changer

1 Answer

Cd won't play

Cd is ejected as soon as it enters the player. The radio begins to play again. I have tried various discs that have worked in there previously and that do play on other players. The player is a P512 cd/tape/radio player.

Posted by on

  • Anonymous Mar 14, 2014

    i drive a 2001 chevy malibu and i used to listen to music with a tape that has a cord attatched. but then out of no where it made a weird clicking sond and it wont even play anymore. it sounds like something broke in the car player, every time i press eject it clicks for about 30 seconds then just quits. it wont eject tapes anymore and it wont play. a small metal flap is whats making the sound it keeps going up and down and just wont play. can i fix it?

  • Anonymous Mar 15, 2014

    when I try to play a CD the disc player says that there is no disc and turns off

×

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

Easy fix, look at the front of your CD player, you should see a little pin hole, insert a paper clip into it and the pop the CD tray open.

Posted on Nov 28, 2006

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Sony CDP-C910 will no longer play cds or eject changer cartridge


Mine did the same thing. My player was primarily used in the garage and the cold weather may have caused my player to do the same thing. I just fixed my player. I removed the top cover and looked at the CD in the play position. In the upper right corner from the CD, you will see a spindle motor with a belt on it. Gently spin the motor back and forth carefully with your finger. I rotated it a half-spin in either direction, careful not to dislodge the belt. When I turned the player back on, the mechanism operated as it normally would and began playing the disc. I was able to eject and reinsert the magazine without any issues, solving the problem. Hopefully that will work for you.

Dec 17, 2012 | Sony CDP-C910 10-Disc CD Changer

3 Answers

My radio/CD player constantly says "ERR" and CD's won't play anymore. It doesn't show the time or the radio station either, just "ERR". I can hear it, like it's trying...


HI lisasmith566 IT is not a fuse problem .
the problem is your the CD part of the radio
must likely the cd is stock or more likely the cd drive motor is defective .
FIRST try pushing eject on radio and see CD comes out if not you need a new radio .

good luck vote

Jul 27, 2011 | 2003 Chevrolet Tracker

2 Answers

Cd player is not reading cds what can i do to repair it.


Subject: Radio With Six Disc CD Changer Does Not Recognize Loaded CD And Displays An "INITIALIZING" Message, CD Will Not Play, CD Cannot Be Ejected, Or Disc Icon Does Not Illuminate (Reprogram Radio)
Models:
2005-2006 Chevrolet Avalanche, Suburban, Tahoe
2005-2007 Chevrolet Colorado, Express, Silverado Classic, TrailBlazer
2005-2006 GMC Yukon, Yukon XL
2005-2007 GMC Canyon, Envoy, Savana, Sierra Classic
2005-2006 HUMMER H2 with Six Disc CD Changer Equipped Audio System (RPO UC6)
Condition
Some customers may comment on any of the following conditions:
• The CD loaded in the radio will not play.
• The CD loaded in the radio will not eject.
• The disc icon on the radio will not illuminate.
• The radio displays an "INITIALIZING" message for approximately 30 seconds after vehicle start up.
Important: Do not attempt to play CDs with paper labels on them in this CD player. The labels may warp or wrinkle and jam the CD player mechanism. Refer to the Compact Disc Care and Cleaning procedure (Document ID# 1656123) in SI for more information.
Technicians are to reprogram the radio with new operating software using the following procedure:
1. If the radio has a CD(s)2008 General will be necessary to reset the radio and remove them
before the radio is reprogrammed. Remove and reinstall the radio fuse to reset the radio and then eject the CD(s). If cycling the power to the radio does not allow the CD(s) to be removed, the radio may have another failure that will not be corrected by the reprogramming procedure that follows. Refer to the Diagnostic Starting Point - Entertainment procedure in SI to begin your diagnosis of this failure to eject CDs concern before reprogramming the radio.
2. Reprogram the radio using the Service Programming System (SPS) with the latest software available on TIS2WEB. Refer to the SPS procedures and the Radio Programming and Set procedure in SI for more information. As always make sure your Tech 2® is updated with the latest software version.
3. Verify proper operation of the radio and make sure that all CDs can be ejected.

Hope helps (remember to rate this).

Oct 03, 2010 | 2005 Chevrolet Trailblazer Ext

2 Answers

My Cd player in my 2004 Jeep grand cherokee laredo wont eject the cd. It recognizes that there is a cd there and will even play the cd when i press the mode button but it wont eject it. Any help is...


I have an 05 jeep grand cherokee and the other day when I went to hit the the eject button on the CD player it automatically went straight to the radio. After I restarted the vehicle I could hit mode and it would begin to play the cd again but if I tried to hit eject it would go to the radio again. It doesnt have a disc changer and everything else on the factory head unit is working find, the radio, all that stuff. I didnt want to start tearing things apart or trying to dig it out. I have sees some others with the same problem on here, but the answer are like "dig in there with tweezers" and I dont think thats the best possible way to solve the problem. Any Ideas?

Aug 25, 2010 | 2005 Jeep Grand Cherokee

1 Answer

Trouble Ejecting CD. CD not playing


One thing have you tried to pull the CD out?

Dec 09, 2009 | 2001 Dodge Caravan

1 Answer

Cd's won't play


Its dirty, try a disc cleaner, (brushes not solution) and if that does not work, its time to replace, (unless the radio is all ya want).
ALSO- if you are trying to play burnt discs, (cd-r, mp3 discs etc) than that could be the issue as not all indash cd players support non store bought cds

Aug 16, 2009 | JVC KD-S640 CD Player

1 Answer

I gave the Bose Wave Radio and 3-cd player to a friend for


Unplug and plug back in. It should go through a automatic process, ejecting any discs that are inside. If all you hear is a mechanical noise, try this again only with the disc trays facing the ceiling.

Dec 29, 2008 | Bose Wave Radio

3 Answers

JVC KD-SX770


Per manual, you can lock a cd in by pressing and holding the power and cd button for moer than 2 secondsthe cd cannot be ejected. if acd is inserted upside down, please -eject appears.

May 18, 2007 | JVC KD-SX770 CD Player

Not finding what you are looking for?
Panasonic CX-DP801 8-Disc CD Changer Logo

Related Topics:

381 people viewed this question

Ask a Question

Usually answered in minutes!

Top Panasonic Car Audio & Video Experts

xxxxxx xxx

Level 3 Expert

4979 Answers

Marvin
Marvin

Level 3 Expert

81285 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17130 Answers

Are you a Panasonic Car Audio and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...