Question about Carrier XHB123D X/Y Series Heat/Cool Air Conditioner

1 Answer

Changed the filter and I'm not getting hot air. how do you light the piolt

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 121 Answers

If you have a standing pilot then on your gas valve turn it to pilot. Push the button in on the gas valve in the pilot position. Hold for 60 to 120 seconds than release the button a turn to on and the furnace should fire up.

Posted on Oct 21, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Heater is not blowing hot air little better than cool air and thermastate keeps changing settings


Thermostat changes all by itself? This is programable thermostat? connects to wifi? Childern around? or near by. Sounds like someone is having fun at your expense.
Thermostat under warranty? if so go that route. If out of warranty, Check out some ot the new thermostats.

Jan 02, 2015 | Filter Air Conditioners

Tip

Low air flow from a/c vents


In the summertime when its hot out, a/c air flow from the vents can start to slow down. When this happens there is a simple thing that all owners can do. Most vehicles today have a cabin air filter inside the vehicle. Most of these filters are easy to get to and change. Then there are some that take a bit more work. A cabin air filter is like a engine filter and works the same way. The cabin air filter catches outside air and debris that gets into the vehicle before it can get to the a/c evaporator. When these filters get dirty they restrict the airflow from the vents. When your airflow is not as good as it used to be, remove the cabin air filter and test the flow again with the filter out. If it changes and blows better, that means the cabin air filter needs to be changed

on Sep 05, 2010 | Air Conditioners

1 Answer

Coame home to find piolt light was out, i can hold the pilot light on but cannot turn to on position for it to fire up


you have to let go of the button after the pilot has heated the thermocouple, then turn it.

Mar 07, 2011 | Air Conditioners

1 Answer

Why doe check filter light stay on. Filter is clean and in the right place. AC works fine


If you are speaking of the Filter light on the thermostat it is just a timed setting on the thermostat in most cases where the thermostat will flash filter every 30, 60 or 90 days depending on the settings. Looking up the user guide will show hot to turn the filter reminder off or how to reset it each time. Normally a thermostat does not have a communication of dirty filter with the actual system itself. More of calendar based filter changing.

Aug 17, 2010 | Airtemp B7D18E7A Air Conditioner

1 Answer

Do I need to clean coils in haier hwro6xc7 air conditioner


You always need to keep both coils clean on your AC.

The evaporator coil (where room air is drawn in and through a filter) - is easy to keep clean - 'just keep the filter changed on a regular basis and you will probably never need to actually clean the evaporator coil. Occasionaly you might need to brush the coil with a brush or something - but this is not a big concern.

The condenser coil (where hot air blows from) is even 'easier,' for you don't have to mess with a filter, just keep the coil clean. You can occasionally pull the unit (when needed) and wash this coil with a water hose. In reality this coil will not get very dirty very fast - although it will (over time) acquire some dirt/dust, but as I say - it is pretty easy to keep clean. Note: Condensing units (split systems) that sit in a yard will get much dirtier much faster than window/thru the wall units such as yours, but you still have to keep a eye on the coil.

A good rule of thumb - is to change the filter (in front of the evaporator coil) - monthly.

As for the condenser coil (where hot air blows from) you can easy see it and just need to keep it clean, with no set (usually) time to do so.

good luck!

May 02, 2010 | Haier HWR06XC5 Wall/Window Air Conditioner

1 Answer

I have a RUUD heating and air unit, Model number rrka-a042jk10e. This connected to a propane tank, we had ran out of gas and now it is refilled but now the piolt will not light. Is there a reset button


Thanks for your Question,
you will need to bleed the line, as you have air in the lines, once you bleed the line it might take a few trys to get it lit again, but keep trying, it should light, one other thing you may want to do as well after you bleed the line, go to the breaker panel and shut the power off to the furnace, wait about thirty seconds then turn the power back on, that resets the circuit board, then try lighting it, let us know how it went, thanks again,
mr.grzz

Jan 26, 2009 | Air Conditioners

1 Answer

I have changed the themocoupler and controler.The piolt light will not stay lit.


you may try removing the pilot assemly and cleaning the pilot tub and jet. comon problem

Oct 08, 2008 | Air Conditioners

1 Answer

What do i do?


You have a recall on that unit. DO NOT OPERATE. her is the link:
http://www.cpsc.gov/cpscpub/prerel/prhtml08/08199.html

Feb 23, 2008 | Rinnai EnergySaver 556 Air Conditioner

Not finding what you are looking for?
Carrier XHB123D X/Y Series Heat/Cool Air Conditioner Logo

Related Topics:

73 people viewed this question

Ask a Question

Usually answered in minutes!

Top Carrier Air Conditioners Experts

Cindy Wells

Level 3 Expert

4754 Answers

yadayada
yadayada

Level 3 Expert

60769 Answers

Lawrence Oravetz

Level 3 Expert

7565 Answers

Are you a Carrier Air Conditioner Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...