Question about Sport & Outdoor - Others

1 Answer

Engine stalls out

1994 big bear starts fine once running and under load,like going up hill
where you need to give it power it stalls out then you have to choke it to start it then ride for 3 to 5mins stalls out again. but you dont have to leave the choke on.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.


    An expert who has answered 20 questions.

  • Contributor
  • 41 Answers

Sounds like a dirty carb or need to rebuild the carb, adj valves, new plug, do a tune up

Posted on Nov 25, 2008

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Runs great but going down hill it goes pa pa out the exuast

This is most likely because you have it in gear going down hill with the throttle closed. This turns the engine into an air brake, and the sound you hear is the compressed air being released during the exhaust cycle.

May 28, 2014 | kawasaki Full Suspension Mountain Bike Men

1 Answer

On 1989 Kawasaki 650 Sx jet ski: I hooked up water to engine with in-line hose connection, turned water on and ran it. It misses at mid to high speed/rpm and sometimes runs just fine. I check plugs and...

Always keep the water pressure low, when the water coming out of the side of machine is cold you should turn down pressure. Engine on first then water, water turned off then wait 10 seconds and turn off machine. If you go out on a ride then park it for say an hour and find water in cylinders I would replace gasket. My shop time on all the J series engines is 20 minutes for head gasket.

Jul 08, 2011 | kawasaki Sport & Outdoor - Others

1 Answer

Engine backfires when climbing hills

Check the spark plug wires...they are bad and the spark is jumping when under load...


Jun 29, 2011 | kawasaki Sport & Outdoor - Others

2 Answers

I have a 2004 60 hp yamaha 2 stroke outboard engine that doesn't start or run well. Once warm and in the water it will idle in nuetral and also in gear. It accelerates in neutral but will die or lack power...

Every sympton you are describing here can be attributed to fuel starvation due to blocked jets and or water in carbs, when your engine dies does it die with dry plugs, or wet oily ones?

Mar 25, 2011 | Sport & Outdoor - Others

2 Answers

Should I start or take my motorcycle for a ride during the winter

yes you should at least start it once a week. bikes do not take sitting well even in a garage. give it about 5 min run time. also add a fuel stabilizer to a fresh tank of gas.

Dec 05, 2009 | kawasaki Full Suspension Mountain Bike Men

1 Answer

How do you take apart the rearend on a 1994 Yamaha big bear 4x4

HELLO; Start by buying a manual, youll need to see what your looking at and the proper way to reassible it. GOOD LUCK........GREASY

Sep 23, 2009 | Sport & Outdoor - Others

3 Answers

196 cc baja mini bike dies if I try and give throttle

Well i had the same Baja mini bike and to be honest with you, you will run into alot more problems with that bike bec they build them so cheap, I and alot of others had 1 thing go after the other on that modle and to me they just aint worth the trouble or money, But check the coil and make sure to

Jul 21, 2009 | Mini Motorized Bike

1 Answer

Yamaha 570 exciter..wont start or run when cold

You need a richer mixture than normal in a cold engine. It sounds like your machine is too lean on the idle circuit. Turn the air screw in on each carb to richen it up. Also, verify the choke is working properly.

Apr 21, 2009 | Sport & Outdoor - Others

1 Answer

1500 Kawasaki Vulcan bottom end bearing failure.

The bearings are not shown in the parts list for the motorcycle. In the U.S. they are avalible under the part number 92028-1477. They are semi-finished and need to be alined honed after installation in the cases.

If the bearing has spun and damaged the cases a salvage se of cases may be the best bet.

Apr 17, 2009 | kawasaki Full Suspension Mountain Bike Men

Not finding what you are looking for?
Sport & Outdoor - Others Logo

Related Topics:

199 people viewed this question

Ask a Question

Usually answered in minutes!

Top Sport & Outdoor - Others Experts


Level 3 Expert

63291 Answers


Level 3 Expert

98694 Answers

Brad Brown

Level 3 Expert

13732 Answers

Are you a Sport and Outdoor - Other Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides