Question about Audio & Video Receivers
SOURCE: no sound out of subwoofer
Connection from receiver subwoofer output jack RCA plug male go into your powered subwoofer low level input with other end of cable, then you need to select Subwoofer YES/NO on the JVC receiver speaker setup menu option, select YES if this is a powered subwoofer you are using, should power up the subwoofer, may have to adjust a test tone balance for multi speaker output also, try trimming up on the subwoofer channel to initiate the signal on if the sub has an auto-on feature.
Posted on Feb 07, 2009
Tips for a great answer:
Jul 11, 2011 | Audio & Video Receivers
Apr 26, 2011 | Audio & Video Receivers
Setting the Subwoofer Information
Register whether you have connected a subwoofer or not.
Before you start, remember....
• There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.
On the front panel ONLY:
1. Press SETTING repeatedly until "SUBWOOFER" appears on the display.
The display changes to show the current setting.
2. Press CONTROL UP / DOWN to select "YES" or "NO."
• Each time you press the button, the display alternates between "YES" and "NO."
YES: Select this when a subwoofer is connected.
NO: Select this when no subwoofer is used.
You cannot use SUBWOOFER OUT ON/OFF on the front panel (see page 14) and adjust the subwoofer output level (see below) when "SUBWOOFER" is set to "NO."
Then continue with setting its relative level and other things.
Feb 06, 2011 | JVC RX-8010V Receiver
Jan 04, 2011 | Audio & Video Receivers
May 24, 2010 | Harman Kardon AVR 2550 Receiver
Oct 25, 2009 | JVC RX-717V
Mar 03, 2009 | JVC RX-6000V Receiver
Feb 07, 2009 | JVC RX-5020VBK Receiver
Dec 21, 2008 | Audio & Video Receivers
May 23, 2008 | JVC RX-8020V Receiver
148 people viewed this question
Usually answered in minutes!