Question about JVC Projection Televisions

1 Answer

My tv keeps switching itself back onto standby, why is this ?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Expert
  • 84 Answers

Your tv is in shut down mode ,the voltage is to high ,it protects the tv

Posted on Oct 18, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

LG 52 Inch Rear Projector TV - switches itself off


LAMP pull it out and see if it looks busted on the inside.

Dec 21, 2009 | LG RU-52SZ51D 52" Rear Projection...

1 Answer

TV switches itself off after 1 minute standby flahes red to green


there seems to be a possibility that your ballast might defective.. i recommend you replace it. It might not have enough voltage to keep up with the new lamp

Jul 02, 2009 | Sony Projection Televisions

1 Answer

We have a Hitachi C28W1TN, which is just under 10 years old that has recently started switching itself off. It goes onto standby by itself and when we switch it back on, it instantly does it again. At...


It's been a while since this post, but I may have had a similar problem with my Hitachi. With no reason it would switching on and off randomly. The problem was with a solder joint on main relay - it was cracked and would not keep the coil powered so i kept flickering on/off. This relay is located on the front of pcb, between high voltage area and the switch and on my tv it is blue. Check all four joints and apply some new solder onto them. Make sure the tv is not connected to mains ;-) Hope this helps

Oct 26, 2008 | Projection Televisions

1 Answer

Our sony tv keeps turning itself on stand by. you press the standby button on the remote and it comes back on for a few minutes then does the same again until it will not turn back on. you have to then...


When the Sony shuts down, the standby light shoulb be blinking a repeated count. Can you please post the model number and that count? The count will indicate the circuit that had a problem causing the set to shutdown.

Thanks,
Dan

Jul 24, 2008 | Projection Televisions

1 Answer

Samsung rear projection tv. When switched on sound comes on then turns itself onto standby


sounds like it has previously overheated leave it in to be repaired shouldnt cost much

Jul 23, 2008 | Projection Televisions

1 Answer

New Sharp Aquos LC37X20E. After 30 mins turns itself off to standby and comes back on after 2-5mins (even though the automatic return to stanby has been set to "disable"). Eventually after...


According to Sharp it is a software problem. Engineer came, installed software update ,10 minute job.....TV worked fine for 1/2 day unfortunately: Then images turned black and white in all channels TV turned itself off, and stanby and OPC buttons started flashing. When TV came back on its own 10 mins later , screen had 2 large square staines superimposed in image (as if it was a burnt screen)...Engineer will be back next week...all quite sad really for a new TV.....will keep u posted

Jul 03, 2008 | Sharp Projection Televisions

2 Answers

Tv help


This is bad. You need to either be under warranty on these big screen TVs or get the service manual. Especially since this is an off brand.

Jan 01, 2008 | Projection Televisions

Not finding what you are looking for?
Projection Televisions Logo

Related Topics:

122 people viewed this question

Ask a Question

Usually answered in minutes!

Top JVC Projection Televisions Experts

easy alberta
easy alberta

Level 2 Expert

132 Answers

Jaime Hernandez

Level 3 Expert

2267 Answers

The Knight
The Knight

Level 3 Expert

68301 Answers

Are you a JVC Projection Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...