Question about Digital Cameras

3 Answers

Cannon PowerShot A630 LCD screen not light up

Posted by on

3 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Remove two small screws on the end of the display and slid off cover.check to see if the blue and yellow wire conectors are properly seated in place. mine were not. i think twisting the display pulls them out

Posted on Mar 15, 2009

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I did what dave5776 said. i had tu push the wires a little back. they were a little out of place. now it works just fine. thank you, dave!

Posted on Jan 26, 2010

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Digital Cameras Master
  • 4,738 Answers

Did you accidentally hit the DISPLAY button on the back of your camera? It turns the screen on and off to save batteries.

Posted on Oct 18, 2008

3 Suggested Answers

  • 1 Answer

SOURCE: canun digital camera powershot A630 lcd screen blank

I also cracked my Canon Powershot A630 lcd screen by dropping the camera. I saw a suggestion to buy a new replacement lens and either have it professionally replaced or try it myself. I ended up doing the replacement myself following instructions I found online. Now it works. Total cost US $63.

I would not recommend trying the replacement yourself, however. There are a few very delicate plastic parts in there which I ended up damaging. Luckily the camera and lcd screen are working great now. But it is probably worth having a professional camera repair shop do the whole job or insert the screen you've purchased. Good luck!

Posted on Jul 26, 2008

  • 4090 Answers

SOURCE: donot have a disk forcannon digital cam A630 powershot, unable to

you can take the card out and load them via a reader and then use software on PC to manipulate and print them,

You can also get it replaced via Canon support

Posted on Aug 30, 2009

t00nz
  • 4738 Answers

SOURCE: CAnnon Powershot A630 LCD screen will not light up when trying to take a pic. I can, however view old pics that I've already taken.

First press the DISP or DISPLAY button to see if that corrects the problem. If not, a stuck shutter is another common failure mode for digital cameras. The symptoms of a stuck or "sticky" shutter are very similar to CCD image sensor failure. The camera may take black pictures (for shutter stuck closed), or the pictures may be very bright and overexposed, sometimes with lines, especially when taken outdoors (for shutter stuck open).
To confirm a stuck shutter, put the camera in any mode other than "Auto", and turn the flash OFF (you don't want to blind yourself for the next step). Next look down the lens and take a picture. You should see a tiny flicker in the center of the lens as the shutter opens and closes. If no movement is seen, then you likely have a stuck shutter. If so, please see this link for further info and a simple fix that may help.

Posted on Nov 11, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I install my Cannon Powershot A630 camera?


You can download the software from this link:

http://www.usa.canon.com/cusa/support/consumer/digital_cameras/powershot_a_series/powershot_a630#DriversAndSoftware

Jan 17, 2012 | Digital Cameras

1 Answer

CAnnon Powershot A630 LCD screen will not light up when trying to take a pic. I can, however view old pics that I've already taken.


First press the DISP or DISPLAY button to see if that corrects the problem. If not, a stuck shutter is another common failure mode for digital cameras. The symptoms of a stuck or "sticky" shutter are very similar to CCD image sensor failure. The camera may take black pictures (for shutter stuck closed), or the pictures may be very bright and overexposed, sometimes with lines, especially when taken outdoors (for shutter stuck open).
To confirm a stuck shutter, put the camera in any mode other than "Auto", and turn the flash OFF (you don't want to blind yourself for the next step). Next look down the lens and take a picture. You should see a tiny flicker in the center of the lens as the shutter opens and closes. If no movement is seen, then you likely have a stuck shutter. If so, please see this link for further info and a simple fix that may help.

Nov 09, 2011 | Canon PowerShot A630 Digital Camera

1 Answer

Canon a630 dropped in the sand - lens stuck in out position and lcd screen stuck at initial screen. suggestions?


Not a good thing. Needs professional help. Contact Canon for nearest repair depot. Do not play too much or you will make things much worse.

Jun 28, 2010 | Canon PowerShot A630 Digital Camera

2 Answers

Powershot A630 powers on just fine, however the LCD screen is black and will not work...


There is a display button on the back, you may have inadvertently shut off the lcd. Cycle the button to check.

Oct 31, 2009 | Canon PowerShot A630 Digital Camera

1 Answer

Donot have a disk forcannon digital cam A630 powershot, unable to


you can take the card out and load them via a reader and then use software on PC to manipulate and print them,

You can also get it replaced via Canon support

Aug 30, 2009 | Digital Cameras

1 Answer

The Lcd Screen is not lighting up properly to see the picture. It is really dark


Canon power shot 630 LCD screen is not light up and can not see the picture

Aug 15, 2008 | Canon PowerShot A630 Digital Camera

1 Answer

Canun digital camera powershot A630 lcd screen blank


I also cracked my Canon Powershot A630 lcd screen by dropping the camera. I saw a suggestion to buy a new replacement lens and either have it professionally replaced or try it myself. I ended up doing the replacement myself following instructions I found online. Now it works. Total cost US $63.

I would not recommend trying the replacement yourself, however. There are a few very delicate plastic parts in there which I ended up damaging. Luckily the camera and lcd screen are working great now. But it is probably worth having a professional camera repair shop do the whole job or insert the screen you've purchased. Good luck!

Jul 11, 2008 | Canon PowerShot A630 Digital Camera

Not finding what you are looking for?
Digital Cameras Logo

Related Topics:

165 people viewed this question

Ask a Question

Usually answered in minutes!

Top Digital Cameras Experts

kakima

Level 3 Expert

96372 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Steve

Level 3 Expert

3287 Answers

Are you a Digital Camera Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...