Where can i find the correct replacement of a Power Supply to my PC: an IX PACCO (all integrated) 2,4GHz.
In the site maybe there isn't more units, unless i search in the
web introducing the serial number of the original Poer Supply.
Maybe i have to search more or better, but, could you help directly in
I will thanks all your guide.
Lic. Claudio Massiani
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones). click here to download the app (for users in the US for now) and get all the help you need. Good luck!
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Check and replace damaged component/s at its back-light inverter board, or replace this board as card basis. If you wish to get some details; check the site linked here. Surf the site with patience. Pull up older posts. It will be best to replace the inverter board as card basis. http://electro-medical.blogspot.com/ http://electronicshelponline.blogspot.com/
To some model sets; especially LED back-lighted types; the back-light inverter circuit will be part of the main power supply board [SMPS]. In such cases, the power supply board might need replacement. To some models sets, the back-light inverter and SMPS section circuit will be integrated at its main board itself. If so; the main board should be replaced. To some models of sets, all these section circuit will be integrated at its main board. If this is the case, you have to replace the main board.
I don't think so. If you need to reset it just open your system and see the CMOS clear jumper just beside the HDD
port there should be three pin just change the jumper If jumper is seted
into 1-2 then you put it 2-3 now system start by default It will go
into CMOS then go to advance setup set the boot prority as first boot
device HDD0 and pree F10 to save it.
Check for power on the A/C outlet. Maybe the circuit breakers were tripped. If there is power, then the power supply installed on the computer might be surged. Replace power supply if thats the case. Normally, there's a button that says 'power' or an image of a lightbulb... you need not use the remote.
If the cord is the ONLY item you need and NOT the terminal block in the dryer, then Home Depot sells replacement cords with a molded plug attached as well as ring lugs on the opposite end for terminating them on the dryer block. You'll need to know if you are using a 3-prong or 4- prong set up in order to get the correct cord. Hope this helps..
just go to computer shop ask ATX power supply for u r computer configuration or else remove the old power supply from the cabinet and take it to computer shop and show him the old one then he will provide the similar capacity Power supply
hello i got the same problem like u,but the thing is i call some1 2 check my p.c and he took my power supply and never give back 2 me,can u let me know that serial # or any info about the power supply....thanks or if u bought 1 4 u...........
Graphic card output connections cannot be shared on two different cards. You will need to install the PCI card then find a way of connecting your screen cable to it depending on type of PC case and motherboard orientation.