Question about X2Gen MG15VT 15" LCD Monitor
My LCD monitor (x2gen) went into sleep mode and won't come out. At first the power light wouldn't even stay on. I would switch it off...turn it on... it would stay blue for a couple of seconds, then go amber (screen would be black). Now when I turn it on it goes blue, then after a couple of seconds the screen flashes "entering sleep mode" then the light goes to amber.
a 6ya Technician can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Technician (only for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
The monitor is on protection.
If it is monitor fault , then the monitor is on protection.
When on protection you keep having a flashing led on front of the monitor , and monitor turning off by itself after a while, that indicates a fault condition.
The flashing light indicates a diagnostic state called protection.
When the Monitor goes on protection there are only two possible causes.
1The internal circuits are jammed because of electrostatic charges accumulating on capacitors, or because of a wrong voltage read by the main chip on your monitor controller board. this started the protection circuit.
2 The protection circuit detected a wrong voltage or a broken contact, identified an internal fault and kicked in , starting the flashing light.
If you are in situation one, then the monitor will reset just unplugging power cord for one or two hours,sometimes even minutes.
If you are in situation 2 , then there is an internal fault.
Common faults that can occur are a blown capacitor on power board, faulty inverter board, faulty input board, or a fault on LCD Digital Controller board.
Check also the video cable or any external connection cable, if the cable is shorting, or the connector is bad, you can get same flashing state because of the video cable.
Try moving the video cable, and if the cable is not built in, then also try a replacement cable.
If under warranty contact the manufacturer ringing the number on the user manual
If you want to repair at your own expenses, just locate any good qualified repairer.
Posted on Apr 25, 2009
SOURCE: MW19R X2gen 19" LCD Monitor
The only solution I have found to work until next time you shut down or reboot is to open the menu, go to Tool Icon and press and hold Reset button for a few seconds. You may have to do this several times before it "takes". Sometimes you may have to press Auto and Reset simultaneously. It is probably not due to your computer, or cables, or connection, video adapter, or board.
Posted on May 04, 2009
Tips for a great answer:
Jan 03, 2014 | Westinghouse Electric L1916HW 19" Monitor
Jul 04, 2012 | Dell Computers & Internet
Dec 29, 2011 | eMachines D Computers & Internet
Nov 19, 2010 | X2Gen MW22U Monitor
Apr 24, 2010 | X2Gen MG19VT 19" LCD Monitor
May 30, 2009 | X2Gen MG19VT 19" LCD Monitor
Nov 19, 2008 | X2Gen MG19MY 19" LCD Monitor
64 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: