Question about Philips 28PW6006 28" TV

3 Answers

TV starts but Does Not show picture or no sound

Hi i would be grateful if any GURU can offer some help. Since yesterday my TV does not show any picture or sound. when I switch it on a little red LED turns on, TV seems to be receiving commands from remote (I can make it out from LED display) I can also hear some tick-tick sound. Sometime it is continues tick-tick-tick from back of TV but NO display or sound. I tried to raise volume to max but I do get to listen anything. any help much appriciated. Thanks a lot! - Tushar

Posted by on

3 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer
Re: TV starts but Does Not show picture or no sound

My 14 months old 32 inches TV has decided to stop working. I can turn it on and off with the remote contol but not the manual control on the side of the tv. The TV does not povide any pictures or sounds and the model is LE32R86WDX I cannot find any troubleshooting to solve this problem. Does anyone have any suggestions?

Posted on Dec 10, 2008

  • Level 1:

    An expert who has achieved level 1.


    An expert who has answered 20 questions.


    An expert that has over 10 points.


    An expert whose answer got voted for 2 times.

  • Contributor
  • 38 Answers
Re: TV starts but Does Not show picture or no sound

Warning! The circuits might contains High Voltage even when the TV is not connected to power. Please handle carefuly!!!

Posted on Jun 04, 2006

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert whose answer got voted for 500 times.

  • Master
  • 3,130 Answers
Re: TV starts but Does Not show picture or no sound

The Tic Tic sound is a result of the high voltage shutdown circuit. Thats what the circuit does if theres a short in the Highvoltage sweep. like maybe a shorted horizontal output transistor??. The only way to really tell is go in and measure the start up voltage and if the Hivoltage comes up and shuts down its a fault in the shutdown or Hhv regulation circuit . if it dosent come up at all then the faults in the Horizontal sweep circuit . Hope this explains a bit? good luck

Posted on Jun 04, 2006

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

TV turns off and immediately on again, by itself.

sounds like a defective str power regulator ic .......but my advice get a tech to resolder all the pins at the power suppy board area, there may be some open pins that triggers the on and off episodes

Jul 18, 2013 | Standard (CRT) Televisions

1 Answer


Set would seem to be either in PIP (picture in picture multiple mode) or the black box might be the TEXT feature which is found in the closed caption menu.

Nov 04, 2012 | Samsung PCL5415R TV

1 Answer

No picture, but have sound

hi....Your micro chip is faulty check the voltage comming out of the 42nd leg it shuold be 13 volts dc if you are not getting that voltage replace the microchip.and the eeprom IC....
thank u rate me!!

Feb 14, 2009 | Samsung DLP HL-P5663W 56" TV

1 Answer

Sony trinitron kv-36fv26 (2000) tv wont show picture

Trires unplug,replug about an hour later see if it reset it self.Not take to the shop the two power ICs help the power it dead.Need it replaced.

Jan 27, 2009 | Sony FD Trinitron WEGA KV-36FV27 36" TV

1 Answer

Half screen showing

keep tv off.
it will only get wors
if sumon dosent work on it soon
the problem you are having in the vertical section of the tv
hav a repairman resolider all conection on the vertical IC and check the serounding componets for falts.

regards daniel.
PS the repair takes me about 15 min.

Jan 13, 2009 | Samsung TXG2746 27" TV

1 Answer

You Asking For Money When Your Website States Advice is FOR FREE

the resolution depends on what type of recv you have hooked up digital,hi def, coax,

Dec 03, 2008 | Standard (CRT) Televisions

1 Answer

My tv turns on and off but there is no sound or picture.


Jun 12, 2008 | RCA TruFlat 27F520T 27" TV

1 Answer

No sound on my 8year old panasonic tv.

It worked fine yesterday. Sound on all channels. Sometimes the picture goes black on channel 6. We can get it back by going up one channel, then back to 6. it is due to cable signal ie weak. now there is no sound this is due to sound section 1 loose connect in sound section 2 speaker 3 problem in sound section some part must have failed.

Sep 17, 2007 | Panasonic CT-32SX12 32" TV

1 Answer

No Picture

Rarely picture tube also shows the same symptom. High pitch sound is due to through deflection area LOT power supply is loaded. Compulsary horizontal output transister short. From your statement i think Lot puncture takes place. Change LOT and horizontal output transister and check tv is now working.

Aug 23, 2007 | Zenith A32B86R 32" TV

1 Answer

Picture fuzzy

hi dear
sound like to me it's screen voltage too hi check some cap on CRT base value 1mf 200v or the same time u can check the cap on horrizantel 2.2mf 250/300/450vot some wear .have good luk

Nov 26, 2006 | Panasonic CT-32D12D 32" TV

Not finding what you are looking for?
Philips 28PW6006 28" TV Logo

236 people viewed this question

Ask a Question

Usually answered in minutes!

Top Philips Standard (CRT) Televisions Experts

Sp Gupta

Level 3 Expert

655 Answers

Jim Evans

Level 2 Expert

186 Answers


Level 3 Expert

485 Answers

Are you a Philips Standard (CRT) Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides