Question about Hotpoint WMA13 Front Load Washer

1 Answer

Hotpoint WMA13 door lock fault

Hotpoint wma13 with door lock fault fitted new interlock fault on display stillpresent door wnt lock and machine wnt start

Posted by on

  • Anonymous Mar 22, 2014

    not draining water

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Hotpoint Master
  • 3,463 Answers

If the door locked light is flashing , then the main board probably has a fault on it, due to a problem with the motor, or the board itself being faulty.
Recommend calling an engineer.

Posted on Jan 04, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My washing machine drum wont turn. The washing machine fills with water then just sits with water in it. It will drain but wont spin It worked fine yesterday, but today nothing. When I turn the drum by...


hello. if it don't turn then it could be the brushes on the motor also check the interlock on the door. any spin problems could be the module control board get back to me if you still have problems

regards
shaun

Jan 03, 2011 | Hotpoint WMA13 Front Load Washer

1 Answer

How to replace bushes on hotpoint wma13


I assume you mean the Brushes in the motor..Remiove lower rear panel of washer.
Unplug lead to motor. Remove earth lead from motor.
Remove belt, and undo 2 screws securing motor to bottom of drum.
Lever motor away from you, and remove motor. and locate brushes at the opposite end to the pulley
Hope this helps you.

Dec 07, 2009 | Hotpoint WMA13 Front Load Washer

1 Answer

Hotpoint wma13 wont empty, think pump is blocked


Yes,
The water pump most be clugged and/or defective.

Aug 18, 2009 | Washing Machines

1 Answer

Washer stopped dead in the middle of cycle


CHECK ALSO the sensor switch underneath where the door close , you gonna need a tester for this task ,hope this helps AJ

May 05, 2008 | Hotpoint WMA13 Front Load Washer

1 Answer

Fitting new module


just switch off the machine and re start the programming procedure again did you get the programme sheet with the module

Jun 13, 2007 | Hotpoint WMA13 Front Load Washer

Not finding what you are looking for?
Hotpoint WMA13 Front Load Washer Logo

Related Topics:

318 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hotpoint Washing Machines Experts

hungoverrr

Level 1 Expert

5 Answers

puggy666

Level 1 Expert

47 Answers

gbob59

Level 3 Expert

2963 Answers

Are you a Hotpoint Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...