Question about Sharp LC-42D43U 42 in. LCD HDTV

1 Answer

Picture Problem with Sharp LCD Model LC-42D43U

Hitting PWR, the green lite on front panel comes on and picture appears for one second THEN the screen goes blank. Any help would be appreciated. Thank you! ahart_2301@yahoo.com

Posted by on

  • 1 more comment 
  • ahart_2301 Oct 16, 2008

    Backlight inverter??? U mean the Main board module on the left of the Pwr Supply right????

  • ahart_2301 Oct 17, 2008

    Ok, we checked all ICs (caps, fuses, etc.). All are good and not burned. I can see On-Scrn Display (OSD) for two secs then blank scrn. We the Main Module between the Pwr Supp and the Slave Inverter (Left hand side) is bad... Your thoughts again... Thx!

  • freelanderyx Jan 08, 2009

    The picture appears for a second then disappears - eventually after switching on and off it stays on. May take up to 40 trys.

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Champion:

    An expert who has answered 200 questions.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 293 Answers

Hi...there,
It's seems your backlight inverter are busted... Need to replaced a new one.

Posted on Oct 15, 2008

  • Cj T
    Cj T Oct 16, 2008

    No, it's the power supply with a built-in inverter. There should be a couple of over-heated capacitors there... Check for those caps for bulged on top. If not sure replaced all the caps...

  • Cj T
    Cj T Oct 18, 2008

    Sure, but you can't always tell all the caps are good...just b'cuz there no burnt mark showing. You'll need a good ESR / Low Ohms Meter to test all the capacitors for leaked too. Yeah sure, if it dies on 2 seconds...that indicated the inverter are busted... need to replaced those busted caps.

×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Picture only turns on for a second


Hi Katy,
This happens mainly due to backlight failure.The inverter needs to be checked.

Sep 24, 2015 | Sharp LC-42D43U 42 in. LCD HDTV

1 Answer

What is wrong with Sharp Aquos LC-40C32U Picture


If you wish to get some details; visit the site linked here. Pull up older posts. Surf the site with patience. http://electronicshelponline.blogspot.com/
Line, faults & possible causes to LCD screen are given with illustrations. You can get an idea about the fault to an extent.
Search the site with the keyword "Line fault"

Jul 01, 2015 | Sharp Flat Panel Televisions

1 Answer

How to fix a Sharp Aquos LC-40C32U Picture


If you wish to get some details; visit the site linked here. Pull up older posts. Surf the site with patience. http://electronicshelponline.blogspot.com/
Line, faults & possible causes to LCD screen are given with illustrations. You can get an idea about the fault to an extent.

Jul 01, 2015 | Sharp Flat Panel Televisions

1 Answer

No picture, sound ok


Take flashlight 2 in from screen and see if there is a picture, if so then it's the inverter board problems or the t-conn board.. In not the video or logic board

Jan 08, 2011 | Sharp LC-42D43U 42 in. LCD HDTV

1 Answer

When I turn the set on a picture only lasts a moment then the power lite and theOPC lite flash, both together then the OPC then both... what should I do?


Unplug,replug tv back hour later.To let the tv to reset it self back to factory.The tv should work now.Not than the Tuner board is dead,that the board that,where the incomming broscasting signal cable plug into it.Tries websites like a Shopjimmy.com,Ebay.com to buy a Tuner board for the replacement.

Sep 13, 2010 | Sharp LC-42D43U 42 in. LCD HDTV

1 Answer

I recently fixed the blinking green light problem following advice here. Now, about a week later, when I turn on the tv, I get image for a few seconds and then the screen goes blank/dark. Green light...


i have the same problem. i just replace the power board because of the "green blinking" light. now, light stays green, picture comes on for a few seconds, then blank....

did you fix your problem.

Aug 31, 2010 | Sharp Aquos LC-37G4U 37 in. HD-Ready LCD...

1 Answer

When the TV is turned on, the picture will only display briefly and then it won't display anymore, though the Power light still indicates that the power is still on.


U still have sound when the picture disappear?Than ur LCD inverter board it dead.No sound picture disappear?Than Ur Tuner signal board it dead.Tries Shopjimmy.com,Ebay.com for those refurbish boards.

Feb 10, 2010 | Sharp LC-42D43U 42 in. LCD HDTV

1 Answer

Sharp aqous lc 37 in tv power no picture,sound


Your control board seem's defective or the inverter board (associated circuits) are bad. This is common in most TFT-LCD Tv's.......

Nov 30, 2008 | Sharp Aquos LC-37GD6U 37 in. LCD HDTV

Not finding what you are looking for?
Sharp LC-42D43U 42 in. LCD HDTV Logo

444 people viewed this question

Ask a Question

Usually answered in minutes!

Top Sharp Flat Panel Televisions Experts

The Knight
The Knight

Level 3 Expert

68157 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Dave Naylor
Dave Naylor

Level 3 Expert

834 Answers

Are you a Sharp Flat Panel Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...