Question about Miele W320 Front Load Washer

Open Question

Miele w320 wash seems to stick on main wash for 1 1/2 hours even when the short button has been pressed

Posted by on

4 Suggested Answers

Bob Gemmell
  • 209 Answers

SOURCE: Miele washing machine model W713 front load - issues

If it is leaking from the waste pump area it may be blocked by a small piece of clothing like a sock or something similar! This will also cause it to take too long to complete a cycle. Remove the rubber hose onto the waste pump and check inside the hose and the pump, make sure the pump spins freely and that nothing is stuck in the hose pipes leading to the pump

Posted on Sep 13, 2007

  • 70 Answers

SOURCE: miele premier novo, the main wash light flashing

Hi
Main wash is a fault indicator. The is a problem within the heater circuit, NTC, element, relay or loose wire. You will have to open front and check.
Remove 3 screw around dispenser and 3 10mm bolt around door. disconnect hose by drain pump and front of machine will open like a door.

Posted on Apr 01, 2010

Testimonial: "thanks, you confirmed what we sort of expected"

  • 3 Answers

SOURCE: Have a Miele W320, during the rinse part of wash

Is the drawer gunged up? Are you using too much detergent?

Remove the drawer, and clean it with hot water and a brush.

Look into the empty drawer slot for any blockages and remove.

Replace drawer, try pouring hot water into the open drawer to try to dissolve and clear any blockages.

Consider using a dosing ball and adding detergent to the drum.

Posted on Jun 30, 2010

  • 91 Answers

SOURCE: I owna W844 Miele washing machine. Shortly after I

Hi dear.If the machine starts the cycle but does not start agitate there are two things could be wrong.1- Good thing loose motor connection,2- Bad one is control board gone.To checked the loose connection,take out the detergent drawer.There are 3 secrews,unsecrew them.Bottom left hand side where the filter lid open it.free the drain hose.Out of the front doorjust under the filter lid,there is one little clip holds the door.free the door & cheked the motor connection.If it's loose,make sure firmly attach the connection housing.put the machine back in order & start the machine.If machine takes the water in & still not rotate the drum(If the rinse "spoolen" light flashing),you need to call miele service centre where you are to get it replace the control board.I hope that helps.Thanks.

Posted on Nov 26, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why does Miele indicator stick on 'rinses'?


Hi dear. Your machine may have one of the three factors playing up.
1- Tacho generator or it's plug on motor
2- Motor carbon brushes
3- Power/ electronic module faulty. Thanks.

Mar 24, 2016 | Miele Washing Machines

1 Answer

Our miele w911 washing machine keeps stopping in the main wash cycle - red light above the tap symbol. What does it mean?


check that the water flow solenoid is operational and not blocking of the spray rinse requriement

Mar 23, 2015 | Miele Washing Machines

1 Answer

I've bought a Miele W310 front loader, which is secondhand, so i don't have a manual. i would just like to know how to do a short wash. There are buttons: 'Short' 'Prewash'...


The short cycle is only an option for Cottons. Make sure that you have set the desired program temp for a cotton cycle (95-30 degrees C). You should be able to select the Short cycle by pressing the button below the Soak light several times. (Note: this cycle is for small amounts of clothing which are lightly soiled - use less detergent (1/2 the amount for a full load).)

If it doesn't work when on the Cotton cycle, then the switch inside the control panel may be faulty.

The manual is available from Miele, http://www.miele.co.uk/customer/OperatingInstructions.aspx . Enter the type of appliance and then scroll down the list. The direct link to the manual for the W310 is http://www.miele.co.uk/Resources/OperatingInstructions/W%20310.pdf .

I hope this helps.

Cindy Wells

Jun 25, 2011 | Washing Machines

1 Answer

Miele 300 child lock


I have the instructions for this machine and was unable to find information on a child lock fort his machine, you can try pressing and holding for 3 - 5 sec the power button or start botton or both at the same time. If neither of thses work i suspect your model does not have a child lock function.

Jul 05, 2010 | Miele W320 Front Load Washer

1 Answer

The door is stuck


Link to the manual...
http://www.miele.co.uk/Resources/OperatingInstructions/W%20320.pdf

Open the flap covering the drain plug on the lower left of the machine (there#s a plastic tool to lever it open stored on the inside of the soap dispenser drawer).

Now the flap is open, you will see a small circular toggle handle. Pull this down, and the lock should pop open.

If you have water in the machine, this will now spill out unless it has already drained. If you need to drain water, place a tray under the circular plug you have uncovered and slowly unscrew it.

Jun 29, 2010 | Miele W320 Front Load Washer

1 Answer

Have a Miele W320, during the rinse part of wash cycle, water pours from underneath the detergent drawer. What can I do to stop this happening?


Is the drawer gunged up? Are you using too much detergent?

Remove the drawer, and clean it with hot water and a brush.

Look into the empty drawer slot for any blockages and remove.

Replace drawer, try pouring hot water into the open drawer to try to dissolve and clear any blockages.

Consider using a dosing ball and adding detergent to the drum.

Feb 18, 2010 | Miele W320 Front Load Washer

1 Answer

Water gets out


check the door rubber for any tears.

Jul 14, 2009 | Miele W320 Front Load Washer

1 Answer

Miele washing machine model W713 front load - issues


If it is leaking from the waste pump area it may be blocked by a small piece of clothing like a sock or something similar! This will also cause it to take too long to complete a cycle. Remove the rubber hose onto the waste pump and check inside the hose and the pump, make sure the pump spins freely and that nothing is stuck in the hose pipes leading to the pump

Sep 13, 2007 | Washing Machines

Not finding what you are looking for?
Miele W320 Front Load Washer Logo

Related Topics:

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Miele Washing Machines Experts

Gerry Harvey
Gerry Harvey

Level 3 Expert

1456 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Richard Roth
Richard Roth

Level 3 Expert

9472 Answers

Are you a Miele Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...