Question about ASUS Terminator A7VT Barebone

2 Answers

Multimedia controller driver needed

I have tried downloading the file from Asus but during install, message 'driver not found'. Grateful for any suggestions to resolve this issue.

Posted by on

  • 2 more comments 
  • Halibut01 Oct 24, 2008

    Hi there,



    The motherboard is an Asus A7VT Rev1.01. I presume this is the information you require as I cannot see any other markings on the M/B.



    Many thanks in anticipation!

  • bassebregts Jan 03, 2009

    I have the exact same problem i got the drivers from the asus site but during installation it says it can't find de drivers :S 

  • bruuge Jan 05, 2009

    me too can't find multimedia audio controller driver.

    anyone got the m/board cd with original drivers on it?




  • rubenvane Jan 07, 2009

    i have the same problem does anyone have a solution.



    Ruben

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I hate to say this but I solved the same problem with a "workaround." If you're not using your only PCI slot, buy (or rummage out of an old computer) a PCI soundcard (soundblaster or whatever) and stick it in. I spent HOURS with the ASUS downloads -=FAIL=-, searching the web -=FAIL=-, trying the ASUS knowledge base -=FAIL=-.

Finally I sucked it up and ripped a soundblaster card out of an old DELL PC and by the time Windows XP booted up and I could get into device manager I had sound.

I'm pissed that I couldn't get the factory system working- but pragmatically- I needed sound and now I have sound so -=SUCCESS=-

If you are using your PCI slot for another device then this may not work for you. I'd be willing to bet you can get an OEM PCI soundcard for peanuts on newegg.com or ebay or your local computer shop if you just need an old or used one. Good luck!

Posted on Jan 29, 2009

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 29 Answers

Let me have the model of your system board and i will get the driver for you

Posted on Oct 23, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My coputer has no sound or audio?


Try installing the latest audio driver -
You can download the drivers from ASUS WEB site. Selectyour model motherboard/computer/laptop, and make sure you select the Windows XPor Vista version of the drivers that matches your Windows operating system.Please click on this link to their WEB support site : - http://support.asus.com/download/download.aspx?SLanguage=en-us

Dec 29, 2010 | ASUS Computers & Internet

5 Answers

Running digi 001 on windows 7


i got digi 001 running on windows 7...
i left my xp on hard disk while installing win 7. it kept xp on folder windows.old folder. in control panel i saw digi as multimedia adapter wich system couldn't recognice. hit "change settings" -> driver -> update driver
used my old windows to search for driver. it found "Dalvin.sys" driver for adapter. installed that. after that windows recogniced digi 001.
downloaded "digidesign asio 6.11" driver installer for win-xp and ran it.
and bingo - it works!
in every step windows was complaining and asking do i want to do this. just yeah'd everything. as i just had a clean install of win 7 i just thought whatta heck i can install everything again if it would not work, but it did.

so in a nut shell:
1: install Dalvin.sys in control panel for digi 001
2: run digidesign asio 6.11 driver installer for win-xp

for me it worked but i absolutely take no responsibility if you mess your system with this! at least reaper got a sound out of it. i haven't tried to record anything yet. but asio settings seemed to work as they used to do in xp.

- veikko-antero

Mar 17, 2009 | Digidesign Mbox 2 Barebone

1 Answer

Speakers will not work


go to control panel, device drivers and check audio devices and see if you are showing any problems there you may want to download or redownload the drivers for you sound card even if there are no errors because it may have missed a file during the install

Mar 16, 2009 | ASUS Eee PC 4G (90OA01A20102111U305Q)...

1 Answer

No multimedia audio controller in my shuttle spacewalker ss50


The website below appears to be the download page for the drivers for your system. Download and install the audio driver for the operating system that you are running.

http://eu.shuttle.com/archive/en/ss50_faq.htm#download

Dec 28, 2008 | Shuttle SpaceWalker SS50 Barebone

1 Answer

Terminator P4.


Mr. A M D K,
If you start installing, especially your video driver, it will immediately tell you if it does not support your hardware.
However, you can also locate a readme.txt file if you extract the files and this file usually lists out the compatible motherboard model numbers.

Thanks,
Lolita

Apr 15, 2008 | ASUS P4-533 Terminator (terminator p4)...

1 Answer

Corrupt driver


One method you can use if you have another computer is you can take the hard drive out of the machine, and connect it to an external enclosure, Ive seen them as cheap as $10. After it is connected to another machine, you can download the driver file that is being reported as corrupt or missing to that computer, extract the file and copy it back to that location on the laptop's drive. This may be a little bit difficult if driver files like ntoskrnl or ntldr go missing, you have technically had your bootstrap loader go bad. There is the possibility that you can copy those files from any other machine running the same version of windows to replace the corrupt files. The only problem with this is that this can occasionally cause more problems than it can fix, because during the installation process these files get embedded with the information about the computer it was installed on, which can panic the registry or driver lists.

Jan 08, 2008 | ASUS Z91N Barebone

1 Answer

Trying to install windows xp on SATA hdd wd raptor 74 g , i can see it in bios  but can`t install windows on it, i boot the cd with data lifeguard tool from western digital but nothing....need help


you need to put the sata drivers onto a floppy disk and when it asks during the xp setup do you want to install any 3rd party drivers say yes and load the drivers from the floppy. The sata drivers with the floppy generator should be on the drivers cd you recieved. 

Oct 25, 2007 | ASUS S-presso Standard S1-P112...

1 Answer

Windows corrupt and driver set


Hi,

Re your queries:
1. "Is their any possible way to save my data from the other operating system which I can currently use?" - possibly

2. Also, can any one help me to attain the drivers for ASUS z91?
Most of the needed drivers for an Asus Z91E are available at the Asus Website > http://support.asus.com/download/download.aspx?SLanguage=en-us&model=Z91E

Most corrupt files in Windows would not delete your Japanese My Documents. What would probably be gone would be ntldr, hal, various dlls and sys files but most of your .doc would remain intact.  If you can boot using the English Win XP Pro and presuming you have 2 different usernames 1 for the Japanese and another 1 for the XP Pro, then chances are that you can still access the Japanese My Documents. It may not be shown but it should be there under the Japanese username.

Assumng you have administrator privileges, Click on Start, Control Panel, Folder Options, View, tick: Show hidden files & folders, untick hide extensions for known file types, untick hide protected operating system files.

This should expose what were hidden before. Of course it is a different problem altogether if you have the 2 OSes installed on 2 different partitions.

Hope this be of some help. Post back how things turn out or should you need additional information.

Good luck and kind regards.

Oct 14, 2007 | ASUS Z91N Barebone

Not finding what you are looking for?
ASUS Terminator A7VT Barebone Logo

Related Topics:

1,213 people viewed this question

Ask a Question

Usually answered in minutes!

Top ASUS Computers & Internet Experts

Brian Sullivan
Brian Sullivan

Level 3 Expert

27725 Answers

Les Dickinson
Les Dickinson

Level 3 Expert

18333 Answers

David
David

Level 3 Expert

756 Answers

Are you an ASUS Computer and Internet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...