When I try to set up mu Cnet CWA-854 wireless AP I am unable to log onto the AP. I have set up this AP successfully before, but I had some trouble recently and I pushed the reset button on the back of the AP so that I could set it up again. However, when I this time follow the instructions I only reach the point where I am to enter the user-name and password. When I enter the factory default user name and password I get this error message in my browser:
"Access Error: Page not found when trying to obtain /home.asp
Cannot open URL /home.asp"
Not much help to get from the user manual as it contains no troubleshooting section.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Rough Translation: GoodeveningI have an accesspointcwa-854andI can notentertheaddress192.168.1.253.Do notknow ifthisis necessaryforfunctionsthatthe truthafter it isinstalledI failto connect.GabrielaBest
Connect your router to computer with ethernet cable then you can access it with following default link. http://192.168.1.1 or http://192.168.0.1 or http://192.168.15.1 or http://192.168.2.1 If you are not able to access it with above ip then check your computers ip address gateway ip is your router ip try with it. Then it ask for user name and password. Type user as "admin" and password as "admin" or "password" or blank. Then you can see configuration page of router. Then configure wan settings and lan settings enable wireless if you want to use wifi .
If you are still not able to access router with above ip and password then press RESET button for 10 seconds it is in back side of router.
Let me know if you need further assistance. Thanks for using FixYa.
Is the power light solid on the router.
Try to reset the router for 30 seconds. then unplug the power to the router and plug it back in, Wait for 1 minute and try to reconfigure the router.
Click Here for step by step solutions.
You need to login to the router and go to the save/reload settings section.
You can reset this Wireless Access Point back to its default settings by clicking on Reset button, and then press OK button to confirm your decision. Note: you can also hold down the reset button on this Wireless Access Point’s panel for more than 10 seconds to reset its default settings back to factory default.
if that is the case there is a possible issue in the firmware of the device (access point) it is either you flash the firmware yourself or better if you report this to CNET because there is a possibility that you are not the only one that is having this kind of problem.
i stayed in our session until now, just got it disconnected hehe, anyway feel free to leave a comment on our session or a rating perhaps, so that we will know where to improve more on our service, good luck buddy.
I couldn't manage to get the CWA-854 to work in repeater mode with WEP encryption enabled, but it is possible to use MAC Access Control even in repeater mode. Just put the CWA-854 in Access Point (AP) mode, add the MAC addresses you wish to allow in the Access Control tab and selecting Allow Listed from the pull-down menu, and then go back to the repeater configuration you posted. In this way, you may not have encryption, but you can still block others from connecting to your wireless network.