Question about Infinity PS-10 Subwoofer

1 Answer

Infinity ps-10 powers up but no boom

It was shortly after a storm when my sub quit working...i install home theaters at my job so i know its hooked up right and all the settings are right on my reciever but the power light still comes on when its plugged in but it doesnt make any noise. Ive taken the amp out and looked it over...nothing seems out of the ordinary and the fuse is still good. Any suggestions?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 13 Answers

Try hooking up a different signal input to your powered sub, another stereo or even a dvd players audio output to the sub will work for a test. Just make sure the subs gain is down before starting. If it still not producing sound, the subwoofers amplifier is bad. I hope this helps.

Posted on Oct 17, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My infinity ps 12 sub blows the inturnal fuse when pluged in ?


make sure you have the right size fuse T3 15 amp L/250V

Feb 25, 2011 | Infinity PS-12 Subwoofer

1 Answer

Is it possible to hook the infinity bu-1 subwoofer to a home theater system where the subwoofer output is straight power say it"s like 25 watts coming out of that one channel and before the original...


In general higher speaker impedance is safer than lower impedance for the amp. Don't expect anything impressive re: audio output from a passive (unpowered) sub if your HTS says it pushes only 25 watts. Without frequency bandwidth and distortion noted the spec is virtually useless as a comparison.

The BU-1 is a powered sub that accepts either RCA Line Level or HIGH LEVEL amplifier power. If you use the latter, impedance is a non-issue because the input feeds the BU-1's internal amp, not the speaker directly. You should be okay.

Perhaps if we knew some specifics about the HTS we could do more than guess.

Jul 21, 2010 | Infinity BU-1 Speaker

1 Answer

My Infinity sub-woofer for my home surround sound system will not turn on. The power light wont even turn on. What can I do to repair this? It seems that no electronic place with repair infinity speakers...


Open it up and see what is in there! You might find a fuse blown. It might have just blown, without a fault, if you are lucky. If not check out the part numbers on the amp board. All semiconductors numbers, then put the numbers into google. You will soon find out if they are obtainable!

Jan 19, 2010 | Infinity PS-10 Subwoofer

1 Answer

PS-212 Suddenly stopped working


I HAVE 4 PS212 AND FROM WHAT YOU ARE DISCRIBING SOUNDS SIMILIAR TO WHAT HAPPENED TO ME. PLAYING THE SUB AT FULL VOLUME AND CLIPPING OCCURED NOT KNOWING THAT THE FAINT SMELL WAS THE VOICE COIL BURNING AND CONTINUING TO PLAY UNTIL KNOW SOUND LESSON LEARNED BUY A BIGGER SUB SYSTEM OR REPLACE YOUR SUB WOOFER.
IN MY OPPINION THIS IS A VERY GOOD PRODUCT WHICH I HAVE BEEN ABUSEING FOR MONTHS . SO QUIT WHINEING AND PAY YOUR DUES.

May 30, 2009 | Infinity PS212 Subwoofer

1 Answer

Sony powered sub keeps clicking in and out.


If you have to hook up other speakers through the sub, then it also amplifies the signals for the other speakers too. You can purchase an new amp for your sub here.

http://www.parts-express.com/speaker-building.cfm

Nov 20, 2008 | Infinity PS-10 Subwoofer

1 Answer

Have an existing ts-1100 home theatre infinity speakers


You cannot use this system with one that does not have a Subwoofer or LFE (Low Frequency Effect) output. Unfortunately, this sub doesn't have a line-level (speaker wire) input. Sorry.

Nov 20, 2008 | Infinity TSS-1100 System

1 Answer

PS-12 subwoofer problem - Infinity Customer Support number?


Fixed the problem...I just purchased another one online (from a store that has a good return problem) and will return the one that doesn't work! Cheers! :)

Jun 26, 2008 | Infinity PS-10 Subwoofer

1 Answer

Inifinity Entra Sub not working


The hum can be from the power supply not properly filtering, and or the output stage also has a short.

There is the chance that the speaker driver coil is now burned, or the power supply is now dead. If ther output stage is shorted and was putting DC on to the speaker cone, this will burn it very easily.

You should sent the unit out and have it serviced, unless you are properly trained, have the service and engineering manuals, and the test equipment to follow up on a proper repair and calibration.

Jerry G.

Apr 27, 2008 | Infinity PS-10 Subwoofer

3 Answers

Infinity PS-12 Subwoofer clicking in and out of standby


Hello,
Unfortunately your subwoofers amplifier circuitry will need to be repaired ,the amplifier is bad and kicking in to protect mode. This mode is designed for safety of the unit and user and sub should not be operated until repaired as it may incur more damage to the components. I hope this helps.

Feb 18, 2008 | Infinity PS-10 Subwoofer

1 Answer

Infinity PS-10 quit working


I think the electronics have a 3 years warranty and the drivers have a five years warranty for this product, maybe you can have it replaced. Maybe the auto on/off signal detector is the culprit.

Dec 09, 2007 | Infinity PS-10 Subwoofer

Not finding what you are looking for?
Infinity PS-10 Subwoofer Logo

425 people viewed this question

Ask a Question

Usually answered in minutes!

Top Infinity Speakers & Subwoofers Experts

 Grubhead
Grubhead

Level 3 Expert

4590 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Matthew Spark
Matthew Spark

Level 3 Expert

1042 Answers

Are you an Infinity Speaker and Subwoofer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...