Question about Pioneer Projection Televisions

1 Answer

I have a Pioneer Pro510HD 53" Pioneer Elite TV purchased in late 11/2001. Not heavily used. The set,working great..suddenly shut down with a snap. Now will not power up. It does have power, red light is on front of set...however cannot get the green power light to come backon and set of course will not work. Any ideas...or service available in the Charlotte, N.C. 28227 area? John Presson 704-545-7808

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

For $15.00 Premium Information Plan.....I WILL TELL YOU HOW I DIAGNOSED/ADDRESSED THE ISSUE AND COMPLETELY RESOLVED THE PROBLEM !

thanks....and I do accept credit card...... John Presson

Posted on Oct 11, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

NEED OPERATING MANUAL FOR PIONEER ELITE PRO 530 HD TV


both may be a little hard to find anymore, the main problem is dead set and that is bad soldering all over the giant power supply board this set uses.

Sep 02, 2012 | Pioneer PRO-530HD 53" Rear Projection...

Tip

Pioneer Pro Elite Rear Projection TV with Sudden loud pop then shuts down


You may need the power supply board resoldered as I had the same problem. The guy listed below can do it for you as I shipped mine from Illinois to him in California... Piece of cake getting the board out of the back and it's not too fraigile... Just pack in bubble wrap and it will be fine. My TV is now working great.

BUT DON'T DELAY AS SOONER LATER TV WILL NOT RESTART..


http://www.avsforum.com/avs-vb/showthread.php?t=402397&pp=30&page=38

Good luck.



cell

on Jan 16, 2008 | Pioneer PRO-200 60" Rear Projection...

1 Answer

I have a Pioneer Pro510HD TV sudenly quit working


a LOT of these have and develop bad solder connections on the Power supply printed circuit board. Follow the power cord inside (unplug set first) and remove the board and examine it for broken or poor solder connections.

I have seen several of these with this problem and I usually just resolder most of the board up and have a working set.


SD TECH

Mar 18, 2010 | Pioneer PRO-510HD 53" Rear Projection...

1 Answer

Pioneer elite pro-530hd tv---no picture at all!


I have a 532nd 53 that shuts off and red stand by lite comes on in the back. If you wait awhile and unplug it and plug it back in it will come on again and then shut off after an hour or two

Jan 19, 2009 | Pioneer PRO-530HD 53" Rear Projection...

1 Answer

Upgrade a PRO510HD to handle HDMI?


Yes, just purchase this HDMI to HD15 (RGB) converter:

http://www.buy.com/prod/aitech-vga-to-hdmi-format-converter-1-x-hd-15-video-in-1-x-stereo/q/loc/111/209868752.html

Dec 21, 2008 | Pioneer PRO-510HD 53" Rear Projection...

1 Answer

Pioneer Elite PRO-520HD wont stay on


It is most likely just solder connections on your power supply. If the only diag LED that lights is on the supply, then thats usually the case. You can unplug the set and remove the supply to fix it with a little soldering. You have to remove the metal board supporter from the bottom of the board and solder quite a few connections. Look for cracked connections on the power connectors to the rest of the set, and also connections on the main transformer. If you need soldering experience, get a kit at radio shack and build a little project to get some practice.

Apr 22, 2008 | Pioneer PRO-520HD 53" Rear Projection...

1 Answer

TV not working


need mor info the tv when turn on after 15 or 30 minuts works fine ?

Mar 21, 2008 | Pioneer PRO-520HD 53" Rear Projection...

1 Answer

PRO-510HDTV



The intermittencies you mention are common on this
series. The PS - power supply - board needs a
virtually complete resolder op, as the solder used in
that run of units was weak and thin. It will not get
better on its own, any more than needed dental work
will.

Send it to me and I will resolder it and send it back.
I have done so on a number of PS boards in this series,
and am running at 100% success on saving the
510/610/710 series of Pioneer Elites when all they need
is the resoldering op. There is a procedure to follow,
so contact me directly.

www.imageperfection.com
510-278-4247

Mr Bob

Nov 08, 2007 | Pioneer PRO-510HD 53" Rear Projection...

Not finding what you are looking for?
Projection Televisions Logo

Related Topics:

139 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pioneer Projection Televisions Experts

Jaime Hernandez

Level 3 Expert

2267 Answers

yadayada
yadayada

Level 3 Expert

61229 Answers

zorbrack

Level 1 Expert

19 Answers

Are you a Pioneer Projection Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...