Question about HP Printers & Copiers

1 Answer

Not printing clearly. picture comes out green with lines accross it, don't know why its happening or how to stop it from happening.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Master
  • 505 Answers

Go to printer properties and check the colour level of your cartridge. Also clean the cartridge

Posted on Oct 09, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hp 2600n line


after you have printed a few pages switch the machine off just as the paper leaves the fuser. then open the front cover and take a close look at the image transfer belt ( black plastic conveyor type belt)
use a torch shone accross the belt to better light the error- if you can see these Green/yellow/cyan lines on the belt then theres a good chance its coming from the toner units- ( also try print quality troubleshooting pages in the menus under diagnostics.look at the individual colour pages and look for any lines or Uneveness about the shaded colour) replace whichever toner is not printing correctly

Jan 22, 2014 | HP Color LaserJet 2600n Printer

1 Answer

Just got new Konica Minolta C224 copier. Prints from computer are perfect but when I try to copy something in color it prints page with thin even cyan or magenta lines. Lines are spaced evenly about 15 mm...


MAKE SURE YOU DO EXACTLY WHAT THE INSTALLATION MANUAL SAYES, INCLUDING DOING THE"Performing Non-Image Area Erase Check" I KNOW ITS A PAIN, BUT IF YOU DONT, YOU SEE WHAT HAPPENS

Aug 24, 2013 | Konica Minolta Bizhub C224 Color Copier /...

1 Answer

When I scan photos there is a vertical line on the resulting picture and I don't know how to remove it or stop it happening


Hello.
Try a basic photocopy, it the page printed displays these lines also then it is a error with the scanning light and this would need to be replaced.
Regards GM

May 28, 2011 | Epson Stylus DX4450 All-In-One InkJet...

1 Answer

All the ink cartridges have been replaced but it is printing stripes accross my pictures or not printing all the picture


Hello, In Purchasing Epson's CX 5400, CX4600, & CX7400 and more, I found out that Epson does not like Generic Printer Cartridges. That sounds like your problem. Also in Purchasing the Brother's . Color that should be Yellow, will turn out Green, etc. These printers have a chip, that will detect if it is Generic or Genunie. When Generic Cartridges, it will print lines thru the words, stripes across the picture and also do a mix match with the colors.

That's what these Companies do., so they can keep selling the ink cartridges. Some Printers, are able to use Generic, but you have to fill them up yourself and I heard, quite MESSY.

So I learned, thru trial and error, that you must use the ORIGINAL Genuine Cartridges for the PRINTERS. I had to replace the printer, but Epson, Lexmark & Brothers are always on sale. My Brother & Epson cost me $50.00 with Rebate. Don’t waste too much ink in cleaning it.

This is the only advice I can give you. If you find this helpful, pls rate me.

Thanks and Good Luck :0)

Jan 17, 2010 | Epson Stylus RX425 Multifunction...

1 Answer

Lexmark z816 the cartridge goes accross as tp


Normally this is caused by the cartridges not being installed correctly. Please go to the Lexmark site www.lexmark.com. Select Technical support, then search using the Z816 model printer. A new search bar will appear. Place the following number ENUS32244 into the box and hit <Enter>. Don

Jun 09, 2009 | Lexmark Z816 InkJet Printer

1 Answer

HP J5780 Problem-Line on printed pages


most likely you have a flat spot on the roller.
that is exactly what is going to happen, when the paper hits the flat spot or a low spot. the paper stops and skips. them the print is coming out smeared.
you can get a repair kit or replacement roller from HP.

Jan 04, 2009 | HP Officejet J5780 All-In-One InkJet...

1 Answer

Black streak on one side


Stop the print with a little practice, half to 3/4 of the way threw machine by opening door at right time. You want the paper to be jammed/stopped after the drum (has image on paper) but before fuser (print should still rub off)

fuser is blue green 300 thingy

If print is line less where stopped then mark is from fuser, replace

If print has line before fuser then it is drum/cartridge

..probally drum..need more info to know for sure, ie you say mark when faxing I guessing you mean receiving, what happens in copy mode is same as printing I'm assuming too

Nov 08, 2007 | Canon imageRUNNER 1370F All-In-One Laser...

Not finding what you are looking for?
Printers & Copiers Logo

Related Topics:

29 people viewed this question

Ask a Question

Usually answered in minutes!

Top HP Printers & Copiers Experts

kakima

Level 3 Expert

96683 Answers

k24674

Level 3 Expert

7987 Answers

Brian Sullivan
Brian Sullivan

Level 3 Expert

27725 Answers

Are you a HP Printer and Copier Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...