Konica Minolta Magicolor 2400W drum cartrige-how to replace?

Verify the drive transmission mechanism to developing unit,the image transfer current terminal and the scanner drive transmission mechanism.

The possible reason for error is the printer does notread chip on the cartridges.
The reader for chips locate inside the printer bottom ofcartridges.
Take out all cartridges and you see reader it is a small blackplastic which come three contact plates.
Just clean it with compressed air and take out if some contactplate is sedentary.

pull its drum cartridge out then fix it again.now restart the printer and check.

check its cartridge if lines are on the drum then replace the drum unit, if drum is clean then replace only the toner.

Hi,

You could buy it from :-

http://cgi.ebay.com/Konica-Minolta-Magicolor-2400-2400W-2430DL-2450-Fuser_W0QQitemZ180400879568QQcmdZViewItemQQptZPrinter_Accessories?hash=item2a00baf7d0

Let me know, if needed further assistance.

Hope i helped you.

Thanks for using ' Fixya ' and have a nice day!!

Removed each toner cartridge, shake it and replace it.

I don't know if this is the real fix but it worked for me at this time..

in the back side of the drum unit is an fuse
just replace the fuse

Start the Konica Minolta Status application on your PC and check the error, you should get more info there.

Reset your Toners and Imaging units for Bizhub and CF series.
http://www.chipreset.eu

To clear chip after refilling toner cartriage.
Go to "Tonerfillyourself.com" I bought refill toner and it includes a new chip and it's not hard to replace it. (Comes with instructions)

try installing it again, first turn off the printer.and then turnit on again. if that wount help, under the cartridge in left or right side, there is a small fuse, you can testit with tester, is it OK, if not, by new fuse