Question about Jensen 100W x 4 Amplifier KA5 Car Audio Amplifier
When I connect the RCA's to the amplifier and try to turn on the amp the protection light is turning on. I would like to request a schematic for this particular amp and if not can I find out how to get them. The amp is a Jensen KA 5 car amp 4 channel 100 watts 1 sub woofer 250 watts.
I'd be inclined to check to make sure there isn't a short circuit somewhere in the output lines. Maybe a wire is crushed against the car's body or bare wires touching or badly fitted RCA plugs. All of these things could activate the protection circuit. If you have a multimeter it would make life easier but don't forget your speakers will show up as 4 ohms so that's not a short. BMW
Posted on May 31, 2006
Tips for a great answer:
May 15, 2011 | Nitro BMW-482 Car Audio Amplifier
Should the amplifier go into protect mode, simply disconnect all RCA and speaker leads, while keeping +12 volt, power ground and remote leads connected.
1. Now turn the amplifier back on, and if the diagnostic LED lights, the amplifier has an internal fault.
2. If not, plug the RCA cables back, and reset the amplifier. If it goes into diagnostic now, the fault lies in the input, either with bad cables or source unit.
3. If the amplifier seems fine with RCA cables plugged in, connect the speakers, one at a time, and if one of the speakers or its wiring is faulty, it will activate the diagnostic
Dec 08, 2010 | Mobile Authority A-500 Car Audio Amplifier
Nov 09, 2010 | AudioBahn A8000T Car Audio Amplifier
Jun 20, 2010 | Rockford Fosgate Punch P4004 Car Audio...
May 18, 2010 | Nitro BMW-482 Car Audio Amplifier
Apr 04, 2010 | Cadence TXA 1000D High Power Mono...
Mar 17, 2010 | Nitro BMW-481 Car Audio Amplifier
Jan 29, 2010 | Rockford Fosgate Power 1001BD Car Audio...
Aug 21, 2009 | AudioBahn A2002T Car Audio Amplifier
642 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: