Question about Digital Camera Accessories

1 Answer

Quantaray Quick Release

I just bought a Quantaray wrist strap for my digital camera with "quick release". The model number is M-6752. I can't figure out how the quick release works. Can you help me out.

Thanks - Ernest

ehilsenrath@comcast.net

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

It took me a while to figure it out. It screws apart. You have to grip the smaller lower portion and twist the larger upper portion. It takes a few tries to get a good grip. After the first time it was easier to repeat.

Posted on Dec 29, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Cable release problem


The D3100 works with the MC-DC2 or compatible remote. See page 177 of the manual: http://www.nikonusa.com/pdf/manuals/kie88335f7869dfuejdl=-cww2/D3100_EN.pdf

Basically, you plug the remote in, then use the button on the remote just as you'd use the shutter release button.

Feb 27, 2014 | Satechi Digital Camera Accessories

1 Answer

The camera arm on my elmo tt02rx will not stay in position, but sags quickly. any easy fix for that?


1. Remove the plastic cover on the inner half of the arm. Four screws: pay attention to where the short one goes. And if you strip them, you're dead, so use a screwdriver that fits them with no slop. Take Elmo to the hardware store with you. The cover on the upper side of the arm is still clipped in, so squeeze the bottom cover in the center to free it. The knob on the end will pop out at some point, so note which way it sits.
2. You can add a bit of tension by bending the metal strap that covers the swivel joint. Remove the three screws at the inner (knob) end. Bend the metal strap to flatten it. Just a bit: you can always try a bit more bend later.
3. Put those three screws back in. THIS IS THE IMPORTANT PART, and useful for any screws in plastic or wood: back each screw off (lefty-loosey) until you feel it click into the threads in the hole. That way, you won't strip the plastic.
4. Test it. If it doesn't stay up, bend the metal strap a bit more; if it stays up, screw the cover back on - same trick backing the screws out first. Done.

Aug 09, 2011 | Elmo Projectors ELMO TT02RX DIGITAL...

2 Answers

How do you make the ML-L3 wireless remote controller for Nikon D7000 work?


Press the release mode dial lock release and turn the release mode dial to the remote control position.

Full details are in the "Release Mode" section of the manual (page 77 in my copy).

Feb 03, 2011 | Nikon ML-L3 Wireless Remote Control...

1 Answer

How do i use the remote to my nikon d5000


Set the camera's release mode to one of the two remote modes. The quick-response remote mode fires the shutter when you press the button on the remote. The delayed remote mode gives you two seconds to hide the remote behind your back before firing the shutter.

To set the camera's release mode, press the [info] button to display the information screen. Press the [i] button to put the cursor into the information display. Use the direction keys on the multiselector to highlight the release mode (fourth item from the top, along the right edge of the screen) and press [OK]. Use the direction keys to highlight the desired mode and press [OK].

For further information, please refer to the "Release Mode" section in the manual (page 65 in my copy of the manual).

Jan 28, 2011 | Nikon ML-L3 Remote Control (D2302005) for...

1 Answer

I have a nikon d5000, and I need the remote control instructions.


Set the camera's release mode to one of the two remote modes. The quick-response mode fires the shutter when you press the button on the remote. The delayed mode gives you two seconds to hide the remote behind your back before firing the shutter.

For full details, look in the camera manual under "Release Mode" (page 65 in my copy of the D5000 manual).

Dec 25, 2010 | Nikon ML-L3 Remote Control (D2302005) for...

1 Answer

How do I use the quantaray close up filter +4


Having gone over a month with no response, I assume this is no longer a problem.

May 28, 2010 | Digital Camera Accessories

2 Answers

How do I install the picture card for my olympus digital camera


Go there.
http://www.trustedreviews.com/images/article/inline/7733-OlympusFE340hatch.jpg

Aug 08, 2009 | Olympus Digital Camera Accessories

1 Answer

Opteka RC-4 Remote Control


Hi guys,
S (shutter release), and 2S (2 Second delayed shutter), are the only
operative buttons for an DSLR. The S (shoot), W+T (zoom control), are for select powershot point-and-shoot cameras.

Thanks,
Buzz

Apr 18, 2009 | Digital Camera Accessories

1 Answer

Card lock release


I have a hp 733 photosmart and to release my card lock I just use my thumbnail to slide the door open a the depress the card slightly and the card is released enough to remove the SD card. Hope this helps you.

Oct 03, 2008 | HP Hewlett-Packard Photosmart Camera Dock...

Not finding what you are looking for?
Digital Camera Accessories Logo

Related Topics:

118 people viewed this question

Ask a Question

Usually answered in minutes!

Top Digital Camera Accessories Experts

kakima

Level 3 Expert

96627 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

old marine
old marine

Level 3 Expert

1476 Answers

Are you a Digital Camera Accessory Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...