Front nose emblem

Toyota attaches their emblems in two ways:
1. By 2 sided tape
2. By prongs
If it is tape carefully remove the emblem with an exacto knife. You can purchase thin 2 way tape from your local hardware store. It is a little thicket than scotch tape. Carefully scrape off the tape from the back of the emblem, apply the new tape and press firmly.
Caution: do not try to take tape off car... you will scratch the paint.
If it is the prongs, gently pry off the emblem with a screw driver. It will snap back on.
Good luck. Hope this helped.

is the lamp bad or or the whole assembly.

but varies by country.
http://www.scantool.net/software/alldata-diy-1-month-subscription.html


generic? the whole deal.
1: gain access to back and remove screws there. (even under fender)
2: on some cars the front nose of car bezel must be removed
gaining true access to lamp housings, and the screws.
disconnect the socket wire (or replace bulb now)
and then the housing screws. bingo its free.
some cars, the hood opens
and there is a plate that extends L/R across front of car.
remove top plate and bingo , lamps.

if it's regular emblem , then it has two plastic pins on the sides (Left and right , very tight fit), it's almost impossible to pull emblem out without braken it.
hood has two plastic clips ,were those pins go.

miata front bumper emblem 2 9/16 inches long
miata front bumper emblem 2 9/16 inches long Results | Listed in category:

• eBay Motors >
• Parts & Accessories >
• Car & Truck Parts >
• Decals, Emblems, & Detailing >
• Emblems

Watch this item here it is miata front bumper emblem 2 9/16 inches long Location: Sandston, VA

on a 300zx lift the bonnet/hood.. inbetween the headlights (the panel with the zed emblem in the centre) underneath it is the standard airbox..to remove the panel there are 2 bolts holding it to the chassis.. undo these and the nose panel lifts out.. yo can know access the stock air box.. undo the clips on it and lift the top off to access the panel filters.. inspect/replace and do steps in reverse to put it all back together

To replace the sidemarker light on a 96 Towncar, raise the hood and open the black plastic flap behind the header panel on that side. There is a 11mm nut down about 5" on the side. Remove it. The screw is on the outside just past the plastic lens. Pull the light out far enough to unscrew the bulb socket.

Think it got two pins held by plastic grommets

Yep...you are gonna have to do this all from the trunk and yes remove the plastic cover.....you may be able to use needle nose to grab and pull on the cable to pop it open.

get some strong dental floss or fishing line and pull back and forth behind the emblem to remove it watch out for the tab behind the emblems

Just put the replacement hood ornament in the hole and use a pair of pliers to pull down and turn the lock 1/4 turn clockwise. It is spring loaded and if you look real close at the ornament you will see what piece to pull down and turn. Right now it is locked in its shipping spot.