Question about Craftsman 25cc Gas Line Trimmer

3 Answers

Cub cadet weed eater wont stay running

New cub cadet 4 cycle still uder warranty runs bout 1 min then dies and wont start for awhile have checked plug and spark arrester would return but i need it today and home depot doesn't have any more of this model

Posted by on

  • fatchuck Apr 21, 2009

    The thing starts and sputters when ideling but I squeeze the trigger and it cuts off , I'v let it run for (really) 5 mins picked it up and gave it a squeeze and it died, really frustrated!!!!

×

3 Answers

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

Air vent in gas cap pluged, push a pin through it

Posted on May 28, 2009

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

I have the same cub cadet 4 cycle. After 20 hours of perfect running it stopped and would not start. Finally found the opening to the carb has a black rubber gasket that had closed up the opening and was hanging halfway out of the carb. I will return it under warranty for repair.
Bob

Posted on Jul 11, 2009

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 659 Answers

Well the thing I would try is get it running allow it to sit on the ground for a few minutes to run if you do pick the unit up do no point your unit downwards point it up in the air while running for a minute. and when its pointing upward slowly give it some juice to get her going good.

I have a few that are really picky like this as well so I know what your going through it took me some time to figure out a plan to get it going and stay going. but it seemed to work ok for me so maybe it will help you out as well.

Posted on Oct 04, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Submitted an e-mail about this, hoping to have a smooth transition. Sincrely, Jane Zeigler


sadly Jane there is nothing FIXYA can do about any membership you signed up for , thru Amazon .

Jan 09, 2017 | Garden

1 Answer

Hi we have a Massey Ferguson Dyna 4 5465 and it was working this morning and then it died we started it up and it ran for about 1/2 a minute when we try starting it now we can hear the fuel pump runs for...


am i to assume its a diesel ,if so sounds like its out of fuel but i could be wrong as its been many years since i have worked on tractors and all the fancy electronic gizmo on modern vehicles can confuse me.Now firstly check the key as no doubt as its a modern one it has a immobilisor and if the head of key loses its chip inside the key head it will never start unlike the old ones that would run on paraffin diesel or petrol ,the later ones were diesel only but again providing they had fuel and oil with the rad topped up they ran 24/7 ,thats a point check the oil level if its low it may stop the engine from starting

Jan 18, 2015 | Garden

1 Answer

How do i fix my powerwasher


If it is electric it will stop every time you release the hand piece. If it is engine driven then check the throttle setting as it should unload the pump and go to idle.

Dec 28, 2014 | Garden

1 Answer

My weed eater will not run with the choke setting wide open.


You may have a pinhole or crack in the small hose that runs from the fuel tank to the carburetor. If equipped with a primer it may also have a small crack or pinhole. Either case may cause the carb to suck air instead of gasoline. Other possible reasons are a plugged muffler causing too much back pressure or a partially clogged fuel filter. (The fuel filter on many weed whackers are located inside the fuel tank at the end of the fuel line.)

Aug 28, 2014 | Garden

1 Answer

Cub cadet will not start?


Post in correct section please

May 02, 2014 | Garden

1 Answer

Led christmas lights stay on when shut off


not neccecarily. leds have become so incredible efficient that the small currents from induction can be in some rare cases enough to dimly light them.(an unplugged extension cord running alongside another live wire will "pick up" some volts. not enough to light up regular bulbs but a led might). try it without the surge protector

Nov 23, 2013 | Garden

1 Answer

Mower wont run


make/model/year of your mower

May 02, 2013 | Garden

1 Answer

I need to know how to set carb to factory settings, already cleaned it. It runs but not right, hard to start


Set flats at neutral to closed just below bowl height. Run mixture screw all way in by hand. Back out 2.5 rounds. Start and observe exhaust. Smells rich turn screw in 1/8 at a time

Jan 08, 2013 | Garden

1 Answer

Pump motor functions normally, pump is not circulating water. Where does the problem lie?


1ST THE PUMP NEEDS TO HAVE WATER TO IT (PRIME) NEXT CHECK THE IMPELLER , IS IT PLUGGED , OR BROKE AKA MOTOR RUNS BUT IMPELLER DOESN'T TURN (( COMMON ) . HOPE THIS WAS OF HELP.. VOTE AND TRY TO BUY USA MADE PRODUCTS .. JAY

Nov 24, 2010 | Garden

2 Answers

Pentair whisperflo 3/4 hp left running over an hour with no water


Sorry to have to tell you but you are going to have to either have your pump rebuilt or replaced. Sounds like you baked the plastic impeller and maybe did even more damage. These pumps require water in order to keep cool.

Jul 02, 2009 | Garden

Not finding what you are looking for?
Craftsman 25cc Gas Line Trimmer Logo

4,304 people viewed this question

Ask a Question

Usually answered in minutes!

Top Craftsman Garden Experts

Wade Mobley
Wade Mobley

Level 2 Expert

448 Answers

Dwain Pippen

Level 3 Expert

376 Answers

Jim Parker
Jim Parker

Level 3 Expert

1040 Answers

Are you a Craftsman Garden Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...